Boot ZCU102 and ADRV9009

Do you have the card in slot HPC-1?

-Travis

can confirm that the card is in HPC-1 slot

Do any IIO devices appear? `iio_attr -a -d` on the board will list them.

-Travis

that command is not recognized.  However, if I do 

iio_info | grep iio:device

It returns `ams` and `ad7291`

Also, FYI with the board booted, the PS_AUX LED is red and the PS LED is flashing.  

The likely issue is the VADJ voltage is wrong. You likely have an early board. See here: https://ez.analog.com/linux-device-drivers/linux-software-drivers/f/q-a/99195/can-t-see-adrv9009-from-linux-zcu102-platform/297370#297370

-Travis

Took me a minute to get the file copied over (I still can't get the ethernet configured) but something worked!  POWER_OK led is on.  I did iio_info | grep iio:device again but only came up with the same things as before though.

Any thoughts?

Can you provide the output of `fru-dump -p -i /sys/bus/i2c/devices/16-0050/eeprom` from the board?

-Travis

root@analog:~# fru-dump -p -i /sys/bus/i2c/devices/16-0050/eeprom
read 256 bytes from /sys/bus/i2c/devices/16-0050/eeprom
DC Load
Output number: 0 (P1 VADJ)
Nominal Volts: 2500 (mV)
minimum voltage: 1800 (mV)
maximum voltage: 2500 (mV)
Ripple and Noise pk-pk 0050 (mV)
Minimum current load 0000 (mA)
Maximum current load 1000 (mA)
DC Load
Output number: 1 (P1 3P3V)
Nominal Volts: 3300 (mV)
minimum voltage: 2970 (mV)
maximum voltage: 3630 (mV)
Ripple and Noise pk-pk 0000 (mV)
Minimum current load 0000 (mA)
Maximum current load 0000 (mA)
DC Load
Output number: 2 (P1 12P0V)
Nominal Volts: 12000 (mV)
minimum voltage: 10800 (mV)
maximum voltage: 13200 (mV)
Ripple and Noise pk-pk 0006 (mV)
Minimum current load 0000 (mA)
Maximum current load 0000 (mA)
DC Output
Output Number: 3 (P1 VIO_B_M2C)
Nominal volts: 2500 (mV)
Maximum negative deviation: 0 (mV)
Maximum positive deviation: 0 (mV)
Ripple and Noise pk-pk: 50 (mV)
Minimum current draw: 0 (mA)
Maximum current draw: 500 (mA)
DC Output
Output Number: 4 (P1 VREF_A_M2C)
All Zeros
DC Output
Output Number: 5 (P1 VREF_B_M2C)
All Zeros

Ok that seems fine. Can you provide the output of dmesg from the board?

-Travis