I'am having a trouble connecting the AD 667 to a pic microcontroller, do i connect all the inputs to the pic or the cs and A3-A0 pins only ?

ger@ on Mar 30, 2018

I'm sending a 16-bit data word from the PIC 16f877A to the AD667, only this data is in the Timer1 register wich we can have access to from one pin , and i really don't know how to send it to the DAC

Top Replies

isantos
Apr 9, 2018 +1 verified
Hi Dina,

If you only use one device, you can directly connect the /CS pin to your microcontroller.

Can you check AD5330, that's a newer 8-bit, parallel interface DAC.

Cheers,

Ivan

Parents

0 ger@ on Apr 7, 2018 12:22 AM over 3 years ago

Hi,

This PIC i'm using has a 8-bit Parallel Slave Port, so i'll be using the same configuration as the one on Figure 8 & Figure 9. It shows that i should use an address decoder, how can i do that ?

Best regards,

Dina.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Reply

0 ger@ on Apr 7, 2018 12:22 AM over 3 years ago

Hi,

This PIC i'm using has a 8-bit Parallel Slave Port, so i'll be using the same configuration as the one on Figure 8 & Figure 9. It shows that i should use an address decoder, how can i do that ?

Best regards,

Dina.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Children

No Data