• LTM4686-1的INTVCC用法

    LTM4686-1的datasheet中，INTVCC和SVIN脚接到一起，并命名为VIN_AUX，范围4.5V到5.75V，请问这个是外部给芯片输入的电源吗？

  • LTM4686-1芯片的INTVCC用法

    LTM4686-1芯片的datasheet参考设计中，将INTVCC和SVIN接到一起，并将网络命名为 VIN_AUX，范围在 4.5V到5.75V，请问这个是外部提供给芯片的电源吗？

  • LTM4686 question

    I have tested the LTM4686 demo，found there is a question.

    While the Run is low voltage（0V）， and Vin voltage is about 12V，for the ideal condition, the output voltage should be 0, but I use multimeter to test the output voltage, found there is about 100mV…

  • LTM4686 MFR_CONFIG_ALL

    After setting the output voltage with RVOUTnCFG and RVTRIMnCFG and starting up,

    we plan to change the voltage with VOUT_COMMAND.

    Is it necessary to change MFR_CONFIG_ALL [6] = ０⇒1b?

    Even if I do not change, sending VOUT_COMMAND will change the output…

  • LTM4686 in extended temperature ranges

    Hello, had a couple of questions on operating the LTM4686 beyond it's rated temperature oil and natural gas equipment:

    1. It is mentioned that the chip “ceases switching action if the control IC exceeds 160C” but will “resume operation after a 10C…

  • Rewriting PSM when using LTM4686 in parallel drive

    I have the following concerns about using LTM4686, please let me know

    The LTM4686 is planned to be used in 4-parallel to drive 0.6V to the MCU.


    Pin-strapresistors configure start-upsettings(output voltage, register address, phase, etc)

    Since I want…

  • LTM4686 PMBUS寄存器转换公式

    HI，

    LTM4686 通过pmbus读出的寄存器的值，怎么样转换为十进制数呢？是否有转换公式呢？如温度、电压、电流等。

  • .file_attr 1="1";

    Building a project imported from CCES 1.1.0 to 2.3.0 I get this error:

    [Error ea5004] "C:\Users\G\AppData\Local\Temp\acc3554de5a000\acc3554de5a001.s":659 Syntax Error in :
    .file_attr 1="1";
    syntax error is at or near text '1'.…

  • AD9523-1  Can I precisely adjust output clock frequency with AD9523-1 (EVAL-AD9523-1)?

    Greetings!

    I would like to inquire if it is possible to achieve precise frequency control with EVALZ - AD9531-1? I'm interested in generating a clock signal that is a multiple of femtosecond laser output pulse rate, which can be something close to 80…

  • Arduino UNO and ADXL345 getting 0 0 0 OR -1 -1 -1 outputs with SPI communication

    I have EVAL-ADXL345Z evaluation board from Analog Device hooked up to the Arduino UNO R3, the code complies and runs fine. At first I could still get…