Hi,

I'm a DFAE in Japan. Our customer designs LTM4647 schematic. He usually has 2.4ohm in his stock and wants to place 2.4ohm between VIN and SVIN instead of 2.2ohm. Is it OK? Why is only 2.2ohm recommended? 

Regards

Hiroyuki

Could I get IBIS and s-parameter files of LTM4644, LTM4647 for PI simulation?

Thanks

I would like to request a review of the LTM4647 schematic.
Check your schematic for problems. Thank you.

I would like to request a review of the LTM4647 schematic.
Check your schematic for problems. Thank you.

Hi Team,

We have few queries for the LTM4647EY,

1. If we are not using the Temperature functionality of the IC i.e. TEMP+,TEMP- , Can we leave the pins open?
2. The datasheet recommends low pass filter to SVIN Pin using 2R2 Ohm and a capacitor, Can you specify…

I have a design with several LTM4647 modules and some other switching regulators that I would like to synchronize.  For the LTM4647:

what signal levels are generated on the CLKOUT pin (Voh/Vol) and what signal levels are accepted on the MODE pin (Vih/Vil…

According to the LTM4647 data sheet, you can measure the temperature of the device by using the voltage difference of 2 different currents thru the Temp pins.  I cannot find in the data sheet what the maximum current allowed is or what the recommended…

I would like to parallel 3 LTM4647 devices to source 90A for a distributed load. However, I cannot use the polyphase feature since I don't have the ability to connect the clkout pins to propagate the phase information. I have just one trace connecting…