• LTC6810 CRC Problem

    Hi People,

    I am attempting to build a rudimentary BMS using the LTC6810-2 monitoring chip. Unfortunately, I cannot communicate to the chip because I am not understanding the Packet Error Code (PEC)  generation using Cyclical Redundancy Check code provided…

  • LTC6810 CRC Problem

    Hi People,

    I am attempting to build a rudimentary BMS using the LTC6810-2 monitoring chip. Unfortunately, I cannot communicate to the chip because I am not understanding the Packet Error Code (PEC)  generation using Cyclical Redundancy Check code provided…

  • RE: LTC6810 demo

    Haeshit.Analog just, quick question on the best way to connect only 4 cell to the LTC6810, it is better to leave upper cells inputs C/S unconnected or lower ones?

    or do I have to connect somehow the remaining inputs?

    Thanks for the answer!

  • LTC3300-1 problem with communication

    Hi everybody,

    I have problem with SPI communication between STM32 and LTC3300-1. I have only one LTC3300 and only one LTC6810. No IsoSPI, no DaisyChain. The ICs have separated CS/SS signals. I want to manage 6S Li-Ion battery pack. The literature, I have…

  • 2*2 MIMO setup

    Hello,

    Iam interested in implementing a MIMO 2*2 scenario where i will use 2 fpgas (1 as the transmitter and 1 as the receiver) where each one  will be connected with one AD-FMCOMMS3-EBZ.
    So the setup will be :
    FPGA_1 + AD-FMCOMMS3-EBZ_1 =Base stati…

  • ADV7610 registers 4:2:2

    Hello

    Thanks in advance.

    I have a input video signal whose format is: YCbCr (Digital YUV) 20 bit (10 chroma + 10 luma).. 1080p60 (1920x1080 60 fps).

    As I can read in this forum ADV7610 only supports four modes for SDR 4:2:2:

                     - 8 bit SDR ITU-R BT.656…

  • 4:2:2 8bit ycrcb

    Hi,

    I have the EVAL-ADV7612-7511p video evaluation board .I'm using 7612 to receive  HDMI inputs from camera(720p @60) , and then feed to 7511 to output the video to the screen. 

    camera -> 7612 --> 7511 --> screen

    When adv7612 output 4:4:4 8bit ycrcb…

  • ADV7403 YUV 4:2:2?

    Can the ADV7403 output YUV 4:2:2 rather than YCbCr 4:2:2?

    Thanks.

    Chris

  • Connect with 2 jtags to 2 Processors

    I'm trying to connect with 2 jtags to 2 processors , BF547 and BF512, at the same time with no succes.

    I have no Problem to connect to each one of them separatly.

    I know that it's Posible to connect to 2 processors at the same time .

    Do you…

  • LTC6804-2 cannot be written

    I'm designing a battery management system for automobiles. I use the chip LTC6804-2. I can read battery voltage, GPIO data and configuration data, but I can't write configuration data.
     
    I also purchased the DEMO test board of LTC6804-2, including…