• RE: LT6600-10 : Chebyshev filter and Ripple Parameter

    Hi Philippe,

    You can use LTC6601-1 a low noise, 0.5% tolerance, 5MHz to 28MHz, Pin Configurable Filter/ADC Driver.

    Attached below will be your configuration and the expected AC response with the bandwidth of 10MHz.

    Let me know if you have clarifications…

  • RE: .file_attr 1="1";

    Hi Gideon,

    Sorry for the delay in responding.

    The cause of the problem is "-file-attr CORE0" and "-DCORE0" both being included on the compiler command-line. Could you delete CORE0 from the "Additional attributes" in Tools Settings > CrossCore Blackfin…

  • LTC2942-1

    Hi.

    The Sense+ pin is connected to both Charger and Load. So,I would like to know how the LTC2942 could determine the operation mode between charge and discharge.

    Thanks.

  • RE: LTC3785-1 PGOOD

    Hi- Yes, abs max is 6V. The UV and OV thresholds are different.

  • ADA4530-1 bias current

    The datasheet says + - 20fA gauranted

    however the datasheet rev B page 17 shows statistical data spreading way outside this for both inputs, in fact the plot states the standard deviation is about 20fA.

    Which is correct ?

    I see other people were querying…

  • Cell Balancing with LTC6812-1

    Hi everyone,

    I am trying to implement passive cell balancing with using external discharge circuit. As I read the datasheet of LTC6812-1 we need to configure DCC bit for the cell we want to discharge. 

    I looked into the configuration register group A and…

  • HMC7044 Group 1 & 2

    configured chip HMC7044 at cmos output mode.

    It is working but I have some problems:

        HMC7044 have 2 group

        Group1:  3 clk + 4 SCLK same phase: CLK0, SCLK3, SCLK5, CLK6, SCLK9, CLK10, SCLK13.

        Group2: 4 CLK + 3 SCLK  same phase: other.

        But group 1 and…

  • ad7768-1

    Hello,

    I want to use the AD7768-1 with 5V AVDD1 = Vref and 3,3V VDDIO.
    In demo-circuits the AVDD2 is connected to probably noisy VDDIO!
    Wouldn't it be better to supply AVDD2 from 5V over a R-C-Filter, that would lower the voltage to around 3V?

    Additionally…

  • ADA4941-1

    Hi All,
    I am looking for OPAMP which can convert single ended signal to differential signal to drive the ADC which has differential input. I have selected ADA4941-1 and tested for -2 and +2 gain configurations which are mentioned in Figure 58 and Figure…
  • AD5755-1 Communication

    Hello I am having trouble communicate with this chip I have the address pin set to AD1 = 1  ADO = 0.  I know I am suppose to send a command NOP  command to read from the desire register.

    I am sending the command in this format:

    command = AD5755_WRITE_CMD…