Hi,
I will design LTC3676-1 power source to NXP i.MX6 DualLite platform.
I would like to know what's the default voltage level of each LDO and Buck regulators if I don't use I2C to configure it ?
Thanks!
Shichin
Hi,
I will design LTC3676-1 power source to NXP i.MX6 DualLite platform.
I would like to know what's the default voltage level of each LDO and Buck regulators if I don't use I2C to configure it ?
Thanks!
Shichin
Hi,
I want to simulate LTC3676 to power IMX6 Dual Lite SoC. Can you provide this model?
Thanks in advance.
I am testing LTC3676-1 for i,mx6 quad.
However, each BUCK regulator generates a lot of heat and the output is not coming out properly.
I met the specs enough to meet the regulations, but I don't know why this is happening.
Please advise.
Hi,
I am using LTC3676 in my design. Is there any sequence of how the buck regulator should be enabled.
Hi
Thanks for the reply. The voltage adjustment on LDO4 is a 1 times change at powerup because this LDO cannot be set with resistor divider unfortunately. I have a few more questions.
Question#1: If I ground the pin EN_LDO34, then after my CPU is started…
If you receive a Cannot load COM module error message when trying to install a driver for a demo board using QuikEval, the following locations can be used to manually install the COM module. After downloading the module, run the installer and the software…
Hi Guy,
Thanks for this. I just copy paste the info here below to close this thread.
Part Number | DC Board Number | Class ID | Url | ||||
ADL5920 | EvalADL5920 | D5596 | ltspice.analog.com/.../ins5596.msi | ||||
LT3964 | DC2424A | D3964 | ltspice.analog.com/.../ins3964.… |
LTM8045 |
LTM8049 |
LTM4651 |
LTM4661 |
LTM4686 |
LTM4676 |
LTM4686-1 |
LTM4676A |
LTM4675 |
LTM4677 |
LTM4678 |
LTM8062 |
LTM8061 |
LTM8052 |
LTM8026 |
LTM8056 |
LTM8064 |
LTM8054 |
LTM8055 |
LTM4600 |
LTM4600HV |
LTM4608A |
LTM4604A |
LTM8032 |