Iam interested in implementing a MIMO 2*2 scenario where i will use 2 fpgas (1 as the transmitter and 1 as the receiver) where each one will be connected with one AD-FMCOMMS3-EBZ. So the setup will be : FPGA_1 + AD-FMCOMMS3-EBZ_1 =Base stati…
Yes you can do that.
The current channel A and B can be populated with Shunt Resistors for each load. Usually the channel B is used to monitor the neutral current in billing or to detect tampering. I assume there is no tamper detection needed…
I have the EVAL-ADV7612-7511p video evaluation board .I'm using 7612 to receive HDMI inputs from camera(720p @60) , and then feed to 7511 to output the video to the screen.
camera -> 7612 --> 7511 --> screen
When adv7612 output 4:4:4 8bit ycrcb…
Thanks in advance.
I have a input video signal whose format is: YCbCr (Digital YUV) 20 bit (10 chroma + 10 luma).. 1080p60 (1920x1080 60 fps).
As I can read in this forum ADV7610 only supports four modes for SDR 4:2:2:
- 8 bit SDR ITU-R BT.656…
Can the ADV7403 output YUV 4:2:2 rather than YCbCr 4:2:2?
I'm trying to connect with 2 jtags to 2 processors , BF547 and BF512, at the same time with no succes.
I have no Problem to connect to each one of them separatly.
I know that it's Posible to connect to 2 processors at the same time .
The voltage on the Vin (Pin34) and (CS, SG, DG and Vbias) pins can be different for normal oparation?
Can I limit the voltage on the pin Vin (Pin34) to 14V applying the series resistor and Zener diode like shown in figure 14 https://www.analog.com/media…
Dear ADI Expert,
My customer uses ADM1172-2 for output short circuit test. The waveform of Output / Gate / Timer is not the same as the datasheet. The datasheet waveform is shown in Figure 1. My customer test results are shown in Figure 2. After the output…
I'm having this same exact issue with the LTC6813 as well. The SPI communications work and a valid PEC is received always, however, the values themselves are 6.5535V and the REF voltages are always at 0V.