• LTC2358-18



  • RE: Looking for ADC true bipolar with high MSPS!

    The LTC2370-16 will not provide the performance you are looking for above fin=100kHz. See the typical performance curves on page 6 of the LTC2370-16 data sheet.

    You might consider the LTC2385-16. SNR and THD performance are within your desired specs…

  • RE: A/D Chip selection help

    Hi EricCho,

       Here some ADCs that you may want to consider in your design. I have chosen these ADCs because of their high sampling rate that is suitable to your input  frequency and voltage range. the links refer directly to the datasheet of the product…

  • 2009-12-18 09:50:18     upgrading

    2009-12-18 09:50:18     upgrading

    Filip Vanalme (BELGIUM)

    Message: 83699   


    I'm finally upgrading to the latest versions of toolchain and kernel. I installed blackfin-toolchain-09r1-10.i386.rpm and blackfin-toolchain-uclibc-default-09r1-10.i386.rpm…

  • RE: AD7961 and Acquisition Time


    Acquisition time is the available time for your signal conditioning circuit to settle the signal at the input to the desired accuracy.  In your case you have a very narrow window that the output signal is valid and thus your input signal conditioning…

  • HMC900LP5E compatibilty with LTC2387-18


    As datasheet says HMC900LP5E has 2vppd output and LTC2387 has maximum 4.096V diff-input. i want to use the whole range of LTC2387. Is there any way i Can use this low pass filter in front of this ADC (ltc2387) through which the full scale range of…

  • 2010-03-22 18:18:04     pata_pcmcia CompactFLASH load error

    2010-03-22 18:18:04     pata_pcmcia CompactFLASH load error

    Doug Bailey (UNITED STATES)

    Message: 87593   

    I am running the 2009R1.1-RC4 tag distro on a BF537 based board.  Configured on

    this board is a pcmcia slot used for interfacing a compactflash drive…

  • 2009-07-18 11:18:11     PORTMUX and PORTFER Configuration doubt

    2009-07-18 11:18:11     PORTMUX and PORTFER Configuration doubt

    Appalayagari Sreedhar (INDIA)

    Message: 77608   


    I am working with 2009R1-RC1 distribution with BF527 based custom hardware.

    I need to configure the PORTMUX and PORTFER registers according…