• LTC2373-16 REFIN capacitor

    Hi,

    As I did not get any answer to my question from CIC EMEA so far , I will try this way...

    I use the LTC2373-16 ADC. In the datasheet it is written that the REFIN pin should be decoupled with a 100nF ceramic capacitor. But in the Eval Board schematic…

  • RE: LTC2324-16 conversion

    Hi John,

    The LTC2324-16 data sheet is being revised. Table 2 will be changed as shown below

    Ideal Fs Lanes SCK cycles SCK Freq Total SCK cycles
    2.00E+06 4 16 6.60E+07 33
    2.00E+06 4 8 3.60E+07 18
    1.50E+06 2 16 4.20E+07 28
    1.00E+06 1 64 8.60E…

  • LTC2325-16 and DC2395A-C

    The doc sheet that came with the DC2395A-C states "alternatively, by connecting the DC2395A into a customer application, the performance of the LTC2325 can be evaluated directly in that circuit". How can I get more information?  The docs include…

  • RE: AD9914 16 QAM

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    …

  • LTC2666-16 MISO output

    Hi,

    I designed a hardware with LTC2666 16bit DAC and I want to output some signals by giving the correct commands (I hope). However, When I send command, address and data word, MISO (or SDO) word doesn't match with the previous input (MOSI or SDI) word…

  • AD9954: Synchronization of 16 AD9954

    Q 

    1.Our design uses the two options described on datasheet page 30. I.e.
    synchronizing with SYNC_IN and SYNC_CLK signals AND a single crystal driving
    multiple (=16) AD9954s. Do you recommend using it this way?
    2a.Datasheet section Synchronizing…

  • 16-bit alternative for AD7193

    Hi,

    We are using AD7193 in our product for Load Cell measurement. Performance of it is quiet good. Now we are in need of a similar ADC with 16-bit resolution.

    16-bit, PGA, SPI, 50Hz rejection, decimate filters, filter word selection, offset correction…

  • RE: cf_axi_adc_core failing with -16

    Thanks Lars, that did the trick.  Looks like the answer was staring me in the face.  "mwipcore" was also being initialized to reg 43C00000. 

  • ADC 16 or 24 bit

    Dear forum

    I was looking for a ADC chip set with 16 bit or 24 bit resolution having capture buffer(FIFO) of 1024 samples and a interrupt line once capture buffer is half filled 512 samples the ADC interrupts the processor to read data from capture buffer…

  • 16-bit Host Wierdness

    Ok, I am working in 16-bit mode, and trying to ge the point I am writing the firmware to the ADV212.  At the moment I have a simple loop that writes the values 0x0000 to 0x000f to the first 16 locations at address 0x00050000 in the ADV212, and then I read…