You should be able to substitute an MLCC in place of the tantalum capacitors for C5 and C9.
I am using the ADF4360-8 to as an input to my IQ receiver which divides the vco frequency by 2. I use a reference frequency of 19.2MHz, an Fpfd of 50kHz and tune the VCO to 300.050MHz (count 6001) and I get these spurs on my ground at 150.000MHz and 150…
Yup, If you can try that first switch to idle mode or continuous conversion mode and see if the issue was resolved then that would be great.
Actually the differential input current is the difference between two analog inputs. If the negative input current has the same magnitude, then the differential current is zero. In practice, the negative input current could be larger or similar in…
Apologies if this is a duplicate question, I couldn't find an answer to it here. I'm using a couple of AD7124-8 boards with 2N2222 transistors and PT100 resistive temperature sensors. The sensors generally seem to be reading fine, but occasionally the…
The answer to this question is discussed here. We should keep the discussion in one place.
Actually if you look at the specs, the datasheet is specified as a minimum value which means that the actual value is guaranteed to not be lower than that but it can go higher than that. I think the virtual eval is usually based from the typical…
Apologies I know this is long overdue. However, if in case someone had a similar issue I would like to recommend to view the link below.
Is it no problem to connect NC pins to GND to reduce AD590 package temperature?
I need to reduce it as much as possible this time.
Have you seen this FAQ post? Please see Item 10 and 11 if that helps.