If you can use the LTC1403-1, an easy solution is to use a fully differential amplifier like the ADA4945 between your filter circuit and the ADC input. Use the same +/-3V supplies for the ADA4945. Use figure 104 of the ADA4945 data sheet and connect VOCM…
Sorry for the delay in responding.
The cause of the problem is "-file-attr CORE0" and "-DCORE0" both being included on the compiler command-line. Could you delete CORE0 from the "Additional attributes" in Tools Settings > CrossCore Blackfin…
The Sense+ pin is connected to both Charger and Load. So,I would like to know how the LTC2942 could determine the operation mode between charge and discharge.
Hi- Yes, abs max is 6V. The UV and OV thresholds are different.
I want to use the AD7768-1 with 5V AVDD1 = Vref and 3,3V VDDIO. In demo-circuits the AVDD2 is connected to probably noisy VDDIO!Wouldn't it be better to supply AVDD2 from 5V over a R-C-Filter, that would lower the voltage to around 3V?
The datasheet says + - 20fA gauranted
however the datasheet rev B page 17 shows statistical data spreading way outside this for both inputs, in fact the plot states the standard deviation is about 20fA.
Which is correct ?
I see other people were querying…
I am trying to implement passive cell balancing with using external discharge circuit. As I read the datasheet of LTC6812-1 we need to configure DCC bit for the cell we want to discharge.
I looked into the configuration register group A and…
configured chip HMC7044 at cmos output mode.
It is working but I have some problems:
HMC7044 have 2 group
Group1: 3 clk + 4 SCLK same phase: CLK0, SCLK3, SCLK5, CLK6, SCLK9, CLK10, SCLK13.
Group2: 4 CLK + 3 SCLK same phase: other.
But group 1 and…
Hello I am having trouble communicate with this chip I have the address pin set to AD1 = 1 ADO = 0. I know I am suppose to send a command NOP command to read from the desire register.
I am sending the command in this format:
command = AD5755_WRITE_CMD…