Hello,

I want to use the LT8606 buck converter.
For selection of the right inductor I need to know the maximum switch current in an overload condition,
as this must be met by saturation current of the inductor. Because some do saturtate hard.
Neither in…

I have a LT8607 DFN on a new custom board.  Input 12v, output 5v, 4.7uh, 10uf in/out, 40k rt, 249k/50k feedback.   EN is about 2v.  The output ramps up to about 1v in 10ms and does not go higher.  This means the startup current is limited to less than 5ma…

I have a system where the output of my regulator may be held high when the system input voltage is absent - basically, exactly the situation mentioned in the LT8607 datasheet (page 15).  While I understand that this may cause the LT8607 to draw its quiescent…

我利用LT8607设计了一个降压电路。电路原理参照dataseet上5V输出那个电路设计的。当空载时，输出电压正常。当带上150欧姆电阻时，输入为6V时，输出正常。输入电压为24V时，输出电压降低为1V。请问这是为什么？

Hi,

My customers are considering LT8607.

In the data sheet, ΘJA is specified, but ΘJC is not listed.

How much ΘJC's are there?

It is the final stage of the design, so I'd like to get an answer as soon as possible.

Best regards,

您好。我利用LT8607设计了一个5V输出的降压电路。当输入为7V时，输出正常。当输入电压为24V时，空载时输出电压为5V，正常。当带载150欧姆时输出电压被拉低至1V。请问这是为什么？