Hello,
is the LT6370 suitable for providing a signal to a right leg drive circuit by splitting its RG into 2 resistors and using the signal at the center tap for the RLD circuit?
Thanks,
Kitong
Hello,
is the LT6370 suitable for providing a signal to a right leg drive circuit by splitting its RG into 2 resistors and using the signal at the center tap for the RLD circuit?
Thanks,
Kitong
In the Mac OS version of LTspice for MAC I cannot find draft the LT6370 component (not listed). There is an LT6370.asy entry in the sym folder, however, if I am trying to open the 6370.asc jig it says "Couldn't find symbol(s): LT6370". It works fine in…
Hello,
I am having some difficulties configuring my LT6370 for bidirectional current-sense.
I am trying to measure across a 0.001ohm shunt resistor with a gain 240ohm gain resistor. Power supplies are +/- 2.5V with a ground reference. I am using 24 Ohm…
I’m using LT6370 as a gain of 100 bridge amplifier, very similar to the application shown on the front page of the datasheet. My circuit needs to operate over a wide temperature range, so offset drift was a key consideration when I picked LT6370…
For United States, where should I purchase the LT6370A (Part No. LT6370AHS8E#PBF).
At the stores mouser.com, digikey.com, I was unable to find them, only the LT6370 for I and H Grades and not the A Grade, and in analog.com only at multiples of 100.
Thanks…
For United States, where should I purchase the LT6370A (Part No. LT6370AHS8E#PBF).
At the stores mouser.com, digikey.com, I was unable to find them, only the LT6370 for I and H Grades and not the A Grade, and in analog.com only at multiples of 100.
Thanks…
Hi
We use AD623 to amplify a 350ohm full bridge strain gauge. Recently due to the global shortage, we switch to AD8220 which was available at the time. Both bridge and AD8220 are running off a single supply of 0-5V. The problem I have is that for the…
A few weeks ago I wrote a blog titled “Behind the Tilted Triangle,” which introduced a new JFET amplifier by way of a brief history of all amplifiers, from tubes to semiconductors. Today I’m going to talk about another new, but very special…