• LT3032

    Is it possible to use LT3032 in a floating design similar to LM317 and LM337 by using diodes? I need low current, low noise positive/negative voltage regulators which can work around 55V-60V region (both positive and negative inputs.)

  • LT3032 Footprint

    Hello,

    I downloaded the footprint of LT3032 from ADI WEB site. But, it is not for LT3032, I think. Because GND and INN are connected. Could you please check it and send me a correct footprint?

    Best Regards,

    Akira

  • LT3032 oscillating

    Hi everyone,

    I am trying to implement the LT3032 voltage regulator for the small footprint and low noise. However, in my current design I have the problem that the positive rail is oscillating with a frequency dependent on load current (a few kHz).

  • LT3032 Positive Output current

    I am trying to use The LT3032 to generate dual outputs of  +/- 4.4V. However, on the positive output I require 250mA and 100mA on the negative output. The datasheet says "Dual 150mA" and  "Output current= +/- 150mA".

    However LTSpice…

  • LT3032. Regulator output voltage error.

    Hello,

    I'm trying to use LT3032 in my design to regulate +/-15V supply voltages coming from DC/DC swithing regulator. 

    The output voltage of LT3032 is set to +/-14V with voltage setting resistors. However, output voltage is about +/-12V. I discovered…

  • LT3032 model for ADIsimPE ?

    Hi 

    I'd like to ask if there is LT3021 model available to be installed in ADIsimPE ? I know there is model available in LTspice, but the current project I am working on was built in ADIsimPE.

    Best

  • Is there a LT3032 model available for ADIsimPE ?

    Original Question: Is there a LT3032 model available for ADIsimPE ? by LuMA

    Hi 

    I'd like to ask if there is LT2023 model available to be added in ADIsimPE ? I know there is a model in LTSpice, but the project I am working on was built in ADIsimPE ?…

  • LT3032- unexpected negative output in start-up with SHDNN=Low

    Hi 

    We have unexpected negative output in start-up with SHDNN=Low.

    Are there any improvement way?

    Rising Negative voltage  after positive voltage(OUTP)=5 is required in the circuit.

    I think that ADP7182 is good in this case.

    https://www.analog.com/jp/products…

  • Can I ask for a model of LT3032 for use in ADIsimPE ?

    Hi 

    I'd like to ask if there is model of LT3032 available to use in ADIsimPE ?  I know there is a model in LTspice. But somehow the project I am working on is built in ADIsimPE 

    Best

  • RE: LT3032IDE-5#PBF PCB Footprint in PDF Request

    The PCB files in .pdf can be found at https://www.analog.com/en/products/lt3032.html#product-evaluationkit. Save the DC1622A - Design Files  and unzip it. All layout files, including the footprint, are in the  DC1622A-pdf folder. Please let me know if you…