• ADP7182AUJZ-2.5-R7, wrong output voltage -4.2 instead of -2.5

    Hi,

         I am using this part in my design to get -2.5V but I am getting -4.2V.

    The EN pin is connected to Vin. The input and output capacitors are Multilayer-ceramic 10uF one on each side. I applying -5V at Vin generated by LT1964ES5-5.

    Can you please let…

  • RE: LTC4162EUFD-LAD charger (12V/2.5 A) problem

    Hi Gaetano,

    This is perfect, thanks.

    2 layers can be difficult for routing. The VCC2P5 cap is particularly critical and doesn't have a great GND return path here due to routing being cut off on the bottom layer:

    The red line shows the current shortest…

  • RE: LT3094 LTspice simulation for -2.5 V

    Hi,

    The answer might be too late for Tim, but others might face a similar problem.

    If you change the output voltage by changing RSET, you also have to adjust the voltage divider from OUT to PGFB. If you don't do that, the startup circuit may try to quickly…

  • RE: minimum gain of LT6600IS8-2.5

    The LT6600IS8-2.5 is a 2.2MHz differential lowpass filter so why are you using a 475MHz inputs signal?

  • Could you pls recommend an IC for 125Mbps clk Dual direction IO 1.8 to 2.5 and also 2.5 to 1.8V

    I Have a 1000M Enthernet   Phy with 2.5 level  the FPGA IO is fixed  1.8V .      so  need a level Translation chip for all TX/RX CLK

    The  clk up to 125Mbps . time rise 1ns.

    could you please recommend one ?

    Thank you very much.

  • ADP7182AUJZ-2.5-R7

    Hi,

         I am using this part in my design to get -2.5V but I am getting -4.2V.

    The EN pin is connected to Vin. The input and output capacitors are Multilayer-ceramic 10uF one on each side. I applying -5V at Vin generated by LT1964ES5-5.

    Can you please…

  • LT1962EMS8-2.5#PBF

    I am performing a Pinsky Analysis to determine the risk of Tin Whiskers for the application we are utilizing the referenced component in. I need to know the plating process(electro-plated, immersion,etc) and the Tin plating thickness over the Leads.

  • ADPD188BI PM 2.5 detection

    Hello

            Could ADPD188B support PM 2.5 detection? Thank you. 

    BR

    Patrick

  • AD5248 2.5 kOhms characteristics

    I need an accurate resistor  with more than 256 Steps. Thats no problem by using the AD5248. I can connect the two potentiometer/ or rheostaten with some other resisors. I dont want describe the circuit i'm using more precisenlty.

    I'm interested in…

  • LTC4120 2.5 kHz operating frequency

    Hi, colleagues, 

    according to documentation the LTC4120 and 25 are searching for a resonance at 2.5 kHz, which is an audible frequency. Does it hurt the experience of the user of this technology? Is it heard when the system is in energy transfer mode?