• HMC641A-DIE datasheet specification

    Hi all,

    Could you please clarify  by the  datasheet for HMC641A-DIE.
    http://www.analog.com/media/en/technical-documentation/data-sheets/hmc641a.pdf

    The pads at the functional diagramm , outline drawing,  at the pad description table and assembly diagr…

  • RE: Differences between HMC641 and HMC641A?

    FormerMember
    FormerMember

    Hi Alan,

     

    The HMC641 (offered in die form and in LP4 and LC4 packages) will be obsolete in next month due to foundry/process discontinuation. The HMC641A  was designed in a similar process from different foundry by
    targeting form, fit, functional drop…

  • 2HD, 3HD data of HMC441-Die and HMC462-Die

    Hi, 

    Could you share the 2nd and the 3rd harmonic distortion data?

    If there is no data of these products, something of the same product series is also fine.

    Regards,

    HM

  • RE: HMC641ALC4 vs ALP4 vs A-DIE frequency range ?

    Hi sss,

    Unfortunately, the lower frequency on the older HMC datasheets were incorrectly specified.
    We are correcting this as we convert the datasheet to the ADI-format.

    We have converted the HMC641A-DIE and the -ALP4 datasheet already, and will convert…

  • ltc2641 die -

    The largest temp range the DAC will operate per the data sheet is -40 to +85 C. If I get the die will it operate at -55 to 125C? I will be mounting the die on ceramic substrate.

    does the assumption that it will work if properly heatsunk although the…

  • HMC939A-DIE

    Please provide S-parameters for HMC939A-DIE. Thanks.

  • Die Temperature

    How can I determine the die temperature of your device?

  • HMC341 die

    Where can I get the S parameter of LNA HMC341 measured on die? The S papameter offered on website is the results measured on test board.

  • HMC598 Die

    Hello,

    Do you have a maximum power consumption for the HMC598 in die form? The data sheet shows 175 mA @ 5 volts, but it's only a typical number and I'm seeing  220 mA @ 5volts, with no input signal or output load. Thanks.

    Best Regards.

  • RE: HMC-ALH435-DIE 10 Ohms on Vgg1

    Hi avatar,

    1) It's in series of the path.

    2)  I would recommend a bondable resistor from AVX.

    3) The resistor in between the bypass capacitors is part of the noise filtering bypass circuit and also is there to protect the gate .

    Thanks,

    DanO