Where can I get the S parameter of LNA HMC341 measured on die? The S papameter offered on website is the results measured on test board.
The largest temp range the DAC will operate per the data sheet is -40 to +85 C. If I get the die will it operate at -55 to 125C? I will be mounting the die on ceramic substrate.
does the assumption that it will work if properly heatsunk although the…
Do you have a maximum power consumption for the HMC598 in die form? The data sheet shows 175 mA @ 5 volts, but it's only a typical number and I'm seeing 220 mA @ 5volts, with no input signal or output load. Thanks.
Please provide S-parameters for HMC939A-DIE. Thanks.
How can I determine the die temperature of your device?
I wanted to Simulate the HMC392A in Microwave office. So i downloaded its S2P file from design resources and as i performed simulation its responses like return loss is better than the datasheet but its gain is decreased to max15.7 dB after simulation…
It's only available in bare die. Below are some alternative devices available in die form that cover the same frequency range.
Firstly if the HMC129 is going to be used for a new design then please be aware that this part is not recommended for new designs.
The 2 die are different due to a process change. The performance between the 2 die should be similar (isolation).…
A die is just a small piece of semiconductor material on which an integrated circuit has been fabricated and cut from a semiconductor wafer. You would not be able to solder a die to a PCB and make direct contact with the signal pads. You would instead…
Are these the correct packaged part numbers for the following die products?HMC913-Die = HMC913LC4BHMC907A-Die = HMC907APM5E
If so, where can I locate the schematics for following evaluation boards? EVAL-HMC913LC4B EVAL-HMC907APM5