Dear,
Can you please help to get BOM(Bill of Materials) file of below each EVB ?
EVAL-HMC406MS8G
EVAL-HMC408LP3
EVAL-HMC425LP3
EVAL-HMC624ALP4
I found HMC425A. This part is pre-released part. Can I get release schedule ?
Thanks a lot.
…Dear,
Can you please help to get BOM(Bill of Materials) file of below each EVB ?
EVAL-HMC406MS8G
EVAL-HMC408LP3
EVAL-HMC425LP3
EVAL-HMC624ALP4
I found HMC425A. This part is pre-released part. Can I get release schedule ?
Thanks a lot.
…We are developing a custom design on Zc706 EVM using AD9680.
I'd like to reload FPGA bitstreams on the fly from the ARM. But when I switch bitstreams the interface to the AD9680 no longer works.
Inside /sys/bus/platform/drivers
Xilinx Watchdog axi…
Q.
What are the differences between glitch free, safe state and no protection transitions in digital step attenuators (DSA)?
A.
Digital Step Attenuators usually have an array of attenuator stages internally and turning on or off the different stages…
Hi cfrick,
1, We attached the full log of the boot of the platform with PuTTY, DOCXwhich is show in the *docx.
2, We didn't configure the board as your picture show, and not connecting the 500MHz signal.
If you don't care about these two extra channels.
Just use this:
Can change these two lines:
#define ADRF4360_RF16_FREQUENCY_HZ…
HMC928 |
HMC929 |
HMC931 |
HMC932 |
HMC933 |
HMC934 |
HMC935 |
HMC247G |
HMC538 |
HMC-C018G |
HMC-C025G |
HMC-C053G |
HMC-C584G |
HMC7056G |
HMC7054G |
HMC7053G |
HMC7056AG |
HMC642G |
HMC642AG |
HMC643G |
HMC644AG |
HMC647 |
HMC647A |
Hello mhennerich . Thank you for the answer. I insert there the Linux kernel boot messages.
Ramdisk addr 0x00000000, Compiled-in FDT at 0x8051dfb0 earlycon: uartlite_a0 at MMIO 0x40600000 (options '115200n8') printk: bootconsole [uartlite_a0] enabled cma…
Hi there,
I've had the chance to test the design now - sorry about the slow response - I was unable to go to the lab for a few weeks due to COVID.
Unfortunately the problem has persisted even with the patch.
No response to ping again unfortunately…
mhennerich Sorry about the slow reply on this, I finished my draft of the designs last week and had the opportunity to test them.
I ran into issues unfortunately.
I'm not sure whether the DAC and ADC bypass works or not yet, as a prerequisite for it is…
You need a PLL which drives a frequency doubler which drives an amplifier. Possible choices might be ADF4371 (PLL), HMC1105 (frequency doubler) and HMC7229 (amplifier). These are not the only choices.