• RE: S parameters for HMC1040

    Hi Freddy,

    s2p is already at ADI web page.

    Package:

    https://www.analog.com/en/products/hmc1040lp3ce.html

    Die:

    https://www.analog.com/en/products/hmc1040-die.html

    Regards

    Ivan S

  • HMC524, HMC499, HMC1040

    Hello,

    Does Hittite offer Agilent Advanced Design System (ADS) files for the HMC524, HMC499, and HMC1040. If not are there any suggestions on how to simulate these parts in ADS.

    Best Regards

  • HMC1040 & HMC1093 power supply

    Hi all,

    Our customer application is the parallel amps & mixer layout for Rx radar,

    and severely space limited, so a simplified local decoupling scheme is preferred.

    The data sheets for the HMC1040 & HMC 1093 shows that all three power supply pins…

  • FAQ: RF Input Power Absolute Max Rating for HMC1040

    Q: Can we exceed the RF Input Power of HMC1040 beyond the Absolute Maximum Rating if the RF input was pulsed? If so, by how much.

    A: The RF input can go up to 6 dBm, pulsed at 10% duty cycle. Normally, we would expect that the device can survive a higher…

  • ADMV8818 in die form?

    Hi,

    Is ADMV8818 available in die form? Or is there any plan to launch it as a die product? 

    Thank you in advance!

  • 2HD, 3HD data of HMC441-Die and HMC462-Die

    Hi, 

    Could you share the 2nd and the 3rd harmonic distortion data?

    If there is no data of these products, something of the same product series is also fine.

    Regards,

    HM

  • RE: HMC985A-Die rf pins interchangeability

    Hi,

    HMC985A-Die can support bi-directional operation, however, the power handling for RFOUT might be lower than RFIN.

    The absolute max RF input power for HMC985A-Die is 30dBm as listed in the datasheet, therefore, I think it is OK to apply 15dBm max to…

  • HMC985 die

    Does anybody know why the HMC985 die has metalization on the edge?

    Thanks.

  • ltc2641 die -

    The largest temp range the DAC will operate per the data sheet is -40 to +85 C. If I get the die will it operate at -55 to 125C? I will be mounting the die on ceramic substrate.

    does the assumption that it will work if properly heatsunk although the…

  • HMC939A-DIE

    Please provide S-parameters for HMC939A-DIE. Thanks.