• RE: (ADuM4120)How fast can ADuM4120 move?

    Hello Kawa,

    There isn't an exact maximum frequency that the ADuM4120 can work at, but there are some limitations:

    1) There is a minimum pulse width. This applies to both the on and off portions of the cycle.

    2) Higher frequency operation will have…

  • RE: ADuM4120 continuous output curren

    Hello,

    Unfortunately, the ADuM4120 can't source or sink very much DC current.

    The ADuM4120 was designed for short durations of output current. If a constant current is pulled through the internal FETs, there is a lot of self heating that will occur…

  • ADuM4120

    Hi all,

    is this part available in AEC-Q100 ?

    Thanks.

    Gerd

  • (ADuM4120)How did you improve isolation voltage?

  • ADUM4120 VDD2 POWER SUPPLY

    ADUM4120 VDD2 has been tested in 250mA and 1A.

    we are evaluating this P/N, for 2A+ current ability, and Switching Frequency 200Khz. Solar PV application.

    Could you tell me the power supply for VDD2 of ADUM4120 recommended value? 250mA?

    we use 16pcs…

  • wants to confirm whether LT8708-1 (LT8708EUHG-1#PBF) can work independently.

    The LT8708EUHG-1#PBF specification shows that the LT8708-1 always operates as a slave to the master LT8708, Mainly used in parallel with LT8708, At present, our customer wants to use LT8708-1 (LT8708EUHG-1#PBF) separately without parallel connection.…

  • .file_attr 1="1";

    Building a project imported from CCES 1.1.0 to 2.3.0 I get this error:

    [Error ea5004] "C:\Users\G\AppData\Local\Temp\acc3554de5a000\acc3554de5a001.s":659 Syntax Error in :
    .file_attr 1="1";
    syntax error is at or near text '1'.…

  • AD9523-1  Can I precisely adjust output clock frequency with AD9523-1 (EVAL-AD9523-1)?

    Greetings!

    I would like to inquire if it is possible to achieve precise frequency control with EVALZ - AD9531-1? I'm interested in generating a clock signal that is a multiple of femtosecond laser output pulse rate, which can be something close to 80…

  • Arduino UNO and ADXL345 getting 0 0 0 OR -1 -1 -1 outputs with SPI communication

    I have EVAL-ADXL345Z evaluation board from Analog Device hooked up to the Arduino UNO R3, the code complies and runs fine. At first I could still get…

  • ADATE305 VDDO_0/1, VSSO_0/1 termination

    Hello,

    In case that VDDO_0 (pin 83), VDDO_1 (pin 93), VSSO_0 (pin 81) and VSSO_1 (pin 95) is unused, what termination is required?

    Best Regards,