• ADXL377 used with Schmitt triggers

    Hi everyone

    I'm really new to electronics and am looking to use an ADXL377 accelerometer to activate another component when a certain acceleration is detected, so was thinking of using a Schmitt trigger for each axis of acceleration which would provide…

  • ADXL377 Damping factor

    Hi,

    Could you please tell me what the typical damping factor is for the ADXL377 accelerometer?

    I seen a similar post to mine was answered but for the ADXL325 and ADXL326  accelerometers, in that answer it was said them accelerometers have an under-damped response…

  • Supply current of ADXL377 at 3.3V

    Hello,

    I would like to know the supply current of ADXL377 at 3.3V. According to the datasheet, the supply current is 300mA(Typ) at Vs=3.0V. What value is the supply current at Vs=3.3V?

    Best regards,

    Akira

  • ADXL377 Output is zero 'g' after trigger for each axis

    After I upload the code on git hub.

    https://github.com/analogdevicesinc/arduino/tree/master/Arduino%20Uno%20R3/examples/ADXL372_example

    When an event is triggered we get 0 G for each axis. Do have any suggestions?

    Here is my wire config with Uno:

    CS…

  • RE: ADXL377 Output impedance

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
  • ADXL377 as an impact test sensor

    I have been experimenting with an ADXL377 accelerometer and have a question as to the validity of the data I am seeing.  All three outputs have a 10 nF capacitor making the bandwidth about 500 Hz.  The ADXL377 unit is mounted to a test sample attached to…

  • RE: how to use adxl377 evaluation board?

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
  • Are there any issues with turning the ADXL377 on and off rapidly to save power?

    My application uses a small coin cell battery, where even 300uA of current is significant power usage. Are there any known issues with duty cycling the power for the ADXL377 sensor? For example turning it on for 2ms (letting it power up then taking a reading…

  • ADXL335 and ADXL377 Accelerometers

    Hi, we bought ADXL335 and ADXL377 Accelerometers for our lab. The typical sensitivity is 6.5 mV/g for ADXL 377, and it is 300 mV/g for ADXL335 when the power is 3 V at 25 C based on the Data Sheet. If we use different power such as 3.3 V, how can do the…