最新的V5.28, Pack Installer里，有ADuCM360/ADuCM361的。
ADuCM360官网页面，“软件代码及系统需求”，有提供“ADuCM36x Device Family Pack (Rev. 1.0.2)”
I have the evaluation board for the ADuCM360 (EVAL-ADUCM360 Evaluation Board | Analog Devices ), Can I use the ADuCM360 IDE with that board?
NO, I will connect the RESET and BM to the GPIO of the SAME ADuCM360:
Running the firmware in the ADuCM360 I will send a command via UART to the ADuCM360 (there is only one ADuCM360 in the design) to start a firmware update of the ADuCM360:
Thank you. Another question is that is the address same in ADuC702x and ADuCM360? Because the SRAM is from 0x2000 0000 to 0x2000 1FFF on ADuCM360. Is there any documentation for ADuCM360 boot-loader memory location?
Hi. Do you have a simple example to use the UART on a ADuCM360 using Aducm360 IDE? Thanks
The ADuCM360 GPIO are similar to the ADuCRF101 GPIOs, and the answer in this thread is valid for ADuCM360:
One of highlight for ADuCM360 is low power. So if your metering device is powered by battery, it's a good reason to choose ADuCM360. Also the accuracy of ADC in ADuCM360 is enough for your measurement.
However an important premise is you need…
My data Acquisition system PCB have one host device communicating with several ADuCM360 ADC devices. All ADuCM360 devices needs to be programmed with different settings. I am planning to use in circuit programming of all ADuCM360s individually by host…
you need to use wires to connect the TC and components with ADuCM360 eval board. You can see many holes at the edge of the board. These holes are be connected with ADuCM360 pins. You can see details from the schematic.