• Assemble, link, load and flash BF706 EZ-KIT

    Here is a minimal command line sequence to assemble, link, generate the loader file and program the boot flash of the BF706, without the use of CCES. Assume the assembly code, mycode.asm, is in the CCES folder:

    easmblkfn -proc ADSP-BF706 mycode.asm

  • In-circuit programming of ADSP-BF706

    Hello.

    I have EV-DEMORAD24G (FMCW radar evaluation bord) which use ADSP-BF706.

    For developing software, I want to know how to program the firmware into SPI flash memory.

    The  SPI flash memory is connected to SPI2 port of ADSP-BF706.

    ADSP-BF706 boot mode…

  • RE: BF706 serial flash W25Q32BV device programming tool problem

    Hi Roman,

    Apologize for the delay in getting back on this.

    I tried the below command and it successfully programmed to the W25Q32 SPI flash of ADSP-BF706 Ez-mini and booted properly.

    -proc ADSP-BF706
    -emu kit
    -driver "C:\Users\jithul\Desktop\Working…

  • RE: How to multiplex the GPIO pins of the ADSP-BF706?

    I have understood from the previous reply that a certain register in the

    ADSP-BF706 should be set with 16 bits each corresponding to a certain

    definition for the ports to be multiplexed. This setting should be done

    through downloading a 16-bit word…

  • RE: Minimal component BF70x solution

    Hi Gavin,

    I would suggest the ADSP-BF706 using the SPI Slave Boot mode. In that mode the processor will boot from the FPGA supplying the proper loader files over the SPI connection.

    Yes, the BF70x will run code out of SRAM without the need of external…

  • Serial Flash Memory in BF706 custom board design

    Hi everybody,

    I am goint to design a custom ADSP-BF706 based board, I want to use the W25Q32FV Serial Flash Memory in the same way as the ADSP-BF706 EZ-KIT MINI does, and I have a few questions:

    1) Can I use cldp tool to flash the W25Q32FV memory with the…

  • ADSP-BF706

    I am searching for the amount of available memory in OTP that is free for userdata.

    I the datasheets there are more different sizes mentioned.

    Please tell me where the userspace is located, or if there are more locations of userspace in OTP.

    Best …

  • RE: ADZS BF706 EZ MINI

    Hi Akshay,
    We have a Board Support Package(BSP) which contains a example codes for ADSP-BF706 Ezkit mini board and the link is below.
    download.analog.com/tools/EZBoards/BF706_Mini/Releases/Release_1.1.0/ADI_ADSP-BF706_EZ-KIT_Mini-Rel1.1.0.exe

    Once you…
  • RE: ADSP-BF706 TDM bus

    Hi DonL,

    Can you please let us know whether you are using a CODEC? If yes, then we would suggest you to refer the ADSP-BF706 EZ-kit mini schematic which shows how ADAU1761(SigmaDSP® low power, stereo audio codec) is connected to ADSP-BF706 Ez-kit mini…

  • RE: ADSP-BF706 Debug

    Thank you for your advice.

    I'll try to read.