• Minimum input from battery manufacturer to PMIC ADP5350

    Hi,

     

    I am using your PMIC ADP5350 in my design. From the ADP5350 datasheet, my understanding is I need to get the below inputs from battery manufacturer. Please confirm that only these register values I need to get it from battery manufacturer or any…

  • adp5350

    Good afternoon,

    I want to know how much time take the change when i enter my data in the registers of the adp5350??

    thanks and best regards,

  • adp5350 & LTspice

    Good morning,

    I want to ask adp5350 power management is available for LTspice. If it available how to add it to the LTspice component .

    Regards,

  • ADP5350 & LTspice

    Good morning ,

    I want to ask if there is a way to work with ADP5350 power management in LTspice because i search for the LTspice component i didn't found it .

    If there is way tell me how to do it.

    Best regards,  

  • ADP5350

    Good afternoon,

    What i should i do when the charger status give me "Suspend" and THR status give "Battery Hot" ??

    For the THR status is always "Battery Hot" when EN_CHG is 'ON' or 'OFF'.

    Thanks,

  • ADP5350

    Good afternoon,

    I want to ask about the appropriate system load when the battery feed the system.

    Thanks and best regards,

  • LTSPICE & ADP5350

    good morning,

    I want to ask if there is a way to work with ADP5350 power management in LTspice because i search for the LTspice component i didn't found it .

    If there is way tell me how to do it.

    Best regards, 

  • RE: Battery internal resistance coefficient dependency on SOC of the battery in PMIC ADP5350

    The SOC algorithm is built in ADP5350 so you just need read the SOC register. ADP5350 would compensate the OCV with the battery resistance coefficient.

  • Demo ADP5350 GUI

    Good Evening,

    I downloaded the labview and the Demo ADP5350 GUI. When i open the demo it give me a message "the vi is not executable. the complete labview development system is needed to correct errors".

     What will I do in this case?

    Thanks…

  • Eval-board adp5350

    Good morning,

    In the Eval-board ADP5350 , the instructions in the charge function evaluation told me to add an additional system load must be connected to the VSYS node to measure the input current limit of the VBUS node across the full programming range…