• ADM811 resistive divide usage

    Hi

    ADM811 is very low consumption current device.

    Can ADM811 use resistive divided input?

    I would like to spend 1mA for resistor.

    (input voltage is 24V, 100uA enough?)

    ADI has more suitable device, I know.

    Sorry I could not select other device.

  • ADM811 input hysteresis and glitch immunity

    what's the typical input hysteresis and glitch immunity of ADM811?

  • RE: ADAU1452 code download

    Hello, Dave

     

    Thank you for your quickly response!

     

    We find the root cause about this issue(hardware design issue):

     

    Root cause:

         The MCU control the ADM811 pin 3(MR), and the ADM811 pin 2(Reset) connct to the ADAU1452 reset pin.

    When we pull high…

  • RE: I have designed the ADAU1702 into an engineering breadboard, using the MINIB eval board as the basis. I've replicated the circuitry as exactly as possible, but cannot get communications working with SigmaStudio via the ADUSB2Z adaptor board... ye...

         Hello,

         It may not matter, but I did notice a difference in reset circuits for the two boards.  The 1701MINIZ board processes the /RESET from the USBi through the ADM811 (into pin 3 and out pin 2):

         Your prototype board directly parallels the ADM811…

  • RE: ADM809T testing question

    Hi Kevin,

    As the threshold of the devices are all tested during production test, it’s unlikely an issue with the device.

    I would advise the customer to check the grounding of the scope, try measure ADM811’s VCC and RESET by referencing the scope ground…

  • RE: ADAU1467 does not boot up properly

    I would like to add one more thing.

    If the ADM811 (or other PSU monitoring system) is triggering a reset when the START_CORE bit is toggled, this indicates a problem in the power delivery system.

    A reset generator like the ADM811 toggles reset if the supply…

  • RE: EVAL AD2S1210SDZ external power supply - Edited

    Rete,

    The device is likely held in RESET by the on-board supervisor, ADM811 (U8).   This device has a reset threshold (for this model) of 3.08V.  Thus if you are only supplying 3V the device will hold the AD2S1210 in RESET and you will not get any excitation…

  • RE: About a waiting time that it takes for SPI communication to be possible after reset the AD2S1210.

    SEan,
    Thank you for your reply.

    I'm sorry.
    My perception was wrong.

    This chart was the chart obtained on the evaluation board.
    As you answered, it was due to the ADM811's very long reset timeout.

    Thank you for your cooperation in the solution.

    Best…

  • Output Voltage of RESET pin of ADM811LARTZ

    Hello support people,

    I have a question about the output level of ADM811L RESET pin.

    In the page-3 of ADM811 datasheet(Rev.G), spesification of minimum level of "high" output is wirtten as "Vcc x 1.5".

    According to this, if I use…

  • EVAL-ADAU1452MINIZ load from microcontroller


    I'm having trouble loading the DSP on  a EVAL-ADAU1452MINIZ board using our microcontroller.   The code is stable and ported from our ADAU1701 target hardware, with the changes required for the ADAU1452. 

    I'm not confident that I've actually put the…