• RE: ADIS16201 use with FX3 Sensor Evaluation Systems board

    Thank you, anmacon, for sharing this!  We are sorry about the confusion.  

    ADIS16201/PCBZ - J1-Pin1 connects to P3-Pin1, on the EVAL-ADIS-FX3.  This will cause the ribbon connector to have pins 13, 14, 15 and 16 NOT connected, on J1 (ADIS16201/PCBZ), since…

  • ADIS16201: Sample rate

    How does ADIS16201 generate the sample rate?

    How accurate is the sample rate?

     

    The SMPL_PRD register sets the sample rate from 122us to 3.7ms and is based on
    an on-chip oscillator with +/-1%/@25degC +/-3% over temperature.
  • ADIS16201 not distinguish angle (tilt) from accleration

    The inclinometer works very well: if I incline the device, I can measure the
    angles correctly. But, even if I move the device in a plain PARALLEL to the
    inclinometer axis, I have some variations in the inclination data! In other
    words…
  • ADIS16201 - Output data rate? - Alternatives with wide bandwidth?

    Good afternoon everyone!

    Does anyone know what is the maximum Output Data Rate (ODR) of the sensor ADIS16201?

    Is it the same ODR when using the SPI port to access directly the digitylized measurement?

    We need a sensor with a bandwidth up to 1 kHz…

  • ADIS16201 timing between the first and second CS cycle

    Is it really necessary to wait 33.6us min between the first and second CS cycle
    when reading via the serial interface?

     

    Yes. It's slow.
  • ADIS16201 and ADIS16209 Pins 8 and 10 Grounded - Performance Issues

    I initially used the ADIS16201 in my design. I tied pins 8 and 10 to ground.
    Later, I redesigned my system and upgraded to the ADIS16209.
    Will ADIS16209 work even if pin 8 and 10 is connected to ground or do we need
    to modify the pcb?
  • RE: Accelerometer calibration tips

    Another option to keep in mind is that ADI provides fully-calibrated devices in the following devices: ADIS16201, ADIS16203, ADIS16209 and ADIS16210. Check out this post for more information on the highest accuracy devices, ADIS16209 and ADIS16210.

  • TAGS LIST: Sensors & MEMS

    ADXL78
    ADXL001
    ADXL278
    ADIS16223
    ADIS16240
    ADIS16209
    ADIS16203
    ADIS16201
    ADXL193
    ADISEVAL
    ADXL1005
    ADIS16000
    ADIS16210
    ADIS16227
    ADIS16228
    ADIS16229
    ADIS16305
    ADXL1001
    ADXL1002
    ADXL1004
    ADXL103
    ADXL151
    A…
  • High resolution inclinometer

    I have a project in that i need to make inclination measures, I choose the ADIS16201 inclinometer because have a good features but the resolution is only 0.0055º an I need at least 0.0025º resolution in the three axis measurements.  The commercial Inclinometer…

  • Comment on EVAL-ADIS USB Driver on New Laptop

    Thank you! I am starting to feel like this relates to a power management issue on USB 3.0.  I was able to get this working when I disconnected the DUT, but as soon as I connect the DUT (hot swapping), it gets lost. When I tried this with a lower power…