• Are ADIN1200 and ADIN1300 supported by U-Boot?

    Original Question: Are ADIN1200 and ADIN1300 supported by U-Boot? by JDuquette210

    I've seen the application notes on manual configuration.  Specifically I have a Beagleboard variant that I'm using an ADIN1300 and ADIN1200 on.  A U-boot initialization…

  • ADIN1200/ADIN1300 Demo Board Gerber

    Hi Sir,

    We need EVAL-ADIN1200 & EVAL-ADIN1300 Demo Board Gerber file can you provide to me refer? my PCB design wait to follow demo board component placement. thanks.

    Best
    Jack

  • About ADIN1200 layout questions

    Hello

    I have a question about ADIN1200.

    Question 1
    In the case of a multi-layer board, is it possible to make a slit on the GND side by prohibiting the pattern on the entire surface under KEEP OUT?

    Question 2

    It states that the thermal pad requires a…

  • ADIN1200 Mean Square Error A

    Could you explain how works the signal quality estimation and how we can use the value from the Mean Square Error A Register (Address: 0x8402) in real application?

  • ADIN1200 and ADIN1100CCPZ Schematic review

    Hi Team,

    We have used ADIN1200 and ADIN1100CCPZ to implement 10BaseT1-L interfaces. Input to ADIN1200 is coming from ethernet switch which is from 100Mbps PHY port and then media conversion is done at ADIN1200 which ultimately gives data to ADIN1100CCPZ…

  • RE: ADIN1200

    Hi Frederico,

    VLANs are configured/managed by Switches normally. 
    Like Baggy Pants models.
    You can refer to our FIDO Family of switches. 

  • RE: How do i build ADIN1200/1300 driver with Linux version 4.1.22.

    Hi,

    Did not test it, but can you try this one?

    https://github.com/analogdevicesinc/linux/blob/2019_R1/drivers/net/phy/adin.c

    Thanks,

    Alexandru

  • ADIN1200 4 power down modes

    My customer asked me about the power consumption comparison among 4 power down modes.

    would you inform me of the tyipical power consumtion in each power down mode?

  • Are ADIN1200 and ADIN1300 supported by U-Boot?

    I've seen the application notes on manual configuration.  Specifically I have a Beagleboard variant that I'm using an ADIN1300 and ADIN1200 on.  A U-boot initialization will be a lot cleaner. 

  • Can ADIN1200 have Back-to-Back Mode for repeaters?

    Hi,

    Can ADIn1200 support back-to-back mode?

    For example for 100Mbps Repeater designs...