• ADAS1000-4BCPZ And ADAS1000-2BCPZ

    Hi,

      Presently  im working on medical equipment for ECG data using ADAS1000-4BCPZ and ADAS1000-2BCPZ.For 6Lead and 12 Lead .Kindly help me out in providing Sample code for reading the ECG data,Lead On ,Lead Off status...

    Thanks in advance

  • ECG 12D ADAS : could i use 2 ADAS1000 (1 master 1 slave) instead of an ADAS1000-2

    Hi everyone,

    Because of the current component shortage, we are wondering if we can replace our ADAS1000-2 by a second ADAS1000 in order to get ECG 12D ? We tried to replace it by an ADAS1000 on an existing board but i can't get a frame from the slave…

  • ADAS1000 PACE

    Dear engineer :

           

     As shown in the picture, I would like to consult the following questions

    1、Does transmission rate affect pacing pulse detection? Is the pacing pulse register configuration different for different transmission rates?  

    PACEEDGETH,PACEAMPTH…

  • RE: ADAS1000-4 and ADAS1000-2 configuration for 12 leads

    Dear Catherine, 

    Can we test this configuration on the ADAS1000 EVM. If yes, Please let me know the settings to be done.

    Thanks 

  • ADAS1000 TESTTONE output

    I'm using the ADAS1000SDZ Eval board interfaced with a ATSAME54 Xplained pro microcontroller.

    I'm using the No OS driver from the official example code. Using the example to generate the TESTTONE 150Hz sine wave.

    I'm using the same register values…

  • ADAS1000 three lead configuration

    Dear engineer :

            Regarding the configuration of the three-lead ECG, if we want to select the I lead as the main lead, that is, the LL as the reference drive lead, the register configuration is as follows:

    0x05 0x85a0202b, 0x03 0x830139ff,  I would like…

  • RE: adas1000

    Hi,

    You need an SDP connector and the evaluation software to communicate with ADAS1000. Please refer to UG-426 (Rev. B) (analog.com)

    regards,

    Mark

  • RLD ADAS1000

    I have simulated the RLD with the external components. I am not sure if the simulation is correct. Could you provide the simulations for gain 100?

  • Gang Mode ADAS1000 and ADAS1000-2 - OPSTAT Register always busy

    Hello all,


    I'm in the process of writing a software driver for an ADAS1000 and ADAS1000-2 ECG front end and I'm getting problems in the gang mode. I tested read frames in the master (ADAS1000) and all worked well but when i tried connect both the Configuration…

  • RLD simulation ADAS1000

    I have simulated the RLD with the external components. I am not sure if the simulation is correct. Could you provide the simulations for gain 100?