Hi,

I would like to use ADA4950-2 as a buffer to measure noise with my chip. May I have the original output noise data for ADA4950-2 as shown in Figure38 in the datasheet? Thanks!

Best,

Nancy

Hi,

Does ADA4950-1/2 power down pin have an internal PU or PD resistor ?

Datasheet does not mention this.

Have a nice day...

Hi,

I am using ADA4950-2 Differential Amplifier to make  differential my DC signal. I hve a output common mode voltage of 1.5 V for this chip
I have two questions:

1) When nothing is connected to INA- and 1.65 V is connected to INA+ I see 1.47 V(apporixmately…

Hi all,

I'm using ADA4950-1YCPZ amplifiers as the last stage in a preamp before driving an AD9650.  The ADA4950 is powered by +/-5V supplies.  The unity gain inputs (pins 2 and 3) are driven by ADA4897s powered by the same +/-5V supplies.  Pins 1 and…

Hi,

i want to use ada4950-1 as an single to differential amplifier with the gain of 1 and output common voltage  at  500mv , i used adr130 to produce the 500mv and connected directly its output to the vocm of ada4950.when i power up the board and just  measure…

Hi,

We do have a catheter cable length of 2.4 meter , trying to understand if the amplifier ADA4950-1 will be able to drive the same or not?

We have set this for a gain of 2. The input level from the FPGA is driven as 2.4V p-p, output of the ADA4950-1 is…

Can you provide advice for proper design considerations for the following questions:

1) The signal we're passing is only operating between 20Hz and 15Mhz.  Would reducing the Bandwidth of the device help prevent oscillations, and if so what would…

My JPEG saga continue...

I am using a BF561 single core to compress a 640x480 YUV 4:2:2 image into JPEG format, employing the ADI JPEG Library tools.  I am getting very poor performance compared with the reference results from the Spec Sheet.  The Spec…