• RE: Questions for LTC6811-1, LTC6812-1

    Hello,

    Would you share your answer about "for maximum power capacity of zener diode - we will look into this and get back to you soon."?

    My customer still need your answers.

    Regards,

    Se-woong

    PS.

    Jay shin is moved to other company.

    So I…

  • LTM4650AIY-1#PBF vs LTM4650AIY-1#3NSPBF

    Could anyone explain what 3NS means on part numbers such as LTM4650AIY-1#PBF vs LTM4650AIY-1#3NSPBF ?

    I cannot find any information.

    thank you

  • "AD5940_WriteReg(REG_AFE_SWMUX, 1<< 1) " is Valid?

    HI.

    I have a question about some code in BATImpedance.cpp.

    ------------------------

    AD5940_WriteReg(REG_AFE_SWMUX, 0);

    or 

    AD5940_WriteReg(REG_AFE_SWMUX, 1<< 1);

    -----------------------

    In the datasheet REG_AFE_SWMUX  (0x0000235C)

    [2:0] reserved , 

  • RE: HMC767: writing 1 to 02h (setting Reference Divider to 1) makes it so no SPI reads are correct

    Hi

    Indeed we have a 10 ohm series resistance on SPI lines. This helped fix communication issues due to glitches and reflections on the line.

    Regarding SPI mode selection on boot up, I don't think that's the issue here, as SPI communications are restored…

  • ECG 12D ADAS : could i use 2 ADAS1000 (1 master 1 slave) instead of an ADAS1000-2

    Hi everyone,

    Because of the current component shortage, we are wondering if we can replace our ADAS1000-2 by a second ADAS1000 in order to get ECG 12D ? We tried to replace it by an ADAS1000 on an existing board but i can't get a frame from the slave…

  • ADSP SC584 SHARC+: Enabling Link Port advances it's DMA's current address by 1 word and decreases current X count by 1

    In our application we are using link ports to transfer data between an FPGA and the DSP at periodic intervals. We setup link port 1 (LP1) in DMA receive mode as prescribed in the HRM (pages 15-15, 15-16). After the data is received, LP1 and it's DMA are…

  • LTC4269-1 - EMC

    Hi,

    We designed a PoE using LTC4269-1 and we are experiencing some emissions problems (EMC). I would like to ask a few questions regarding to my design and the  LTC4269-1 demo board, please we need to address this issue using a private channel. 

    Thank you

  • LT3045-1 Set Capacitor

    Hi,

    I am using the LT3045-1 to post-regulate the output of a switching regulator.

    On page 18 and 19 of the datasheet of LT3045-1 I saw that using a ceramic capacitor at the SET pin can cause significant output noise due to piezoelectric response.

    However…

  • ADV7341 application problems 1

    Adv7341 chip is used to output color stripe video. The oscilloscope collects and outputs waveforms where the positive level at the lowest point is not the negative level. According to the manual, the minimum level of waveform is -300mv. The lowest level…

  • PSE controller LTC9101-1

    LTC9101-1 IEEE802.3bt (PoE 2)PSE controller , we need application note and other reference design files, could you please advise it ?