• RE: 'Input Bias Current Drift Distribution' ADA4806

    Hi Yoshinari,

    I will check whether that information is available and get back to you.

    May I ask why this you need this information? What is your application?

    Thanks!

    Kris

  • RE: .file_attr 1="1";

    Hi, Thanks for replying. I had tried the "-no-auto-attrs" with no improvement. The same error reappears elsewhere if I delete the source file causing the problem. It also occurs in the standard "BF609_init" project, so I have attached those files. The…

  • Composite amplifier using ADA4637-1 and ADA4870-1

    I want to build a composite amplifier using the Figure 77 of the datasheet ADA4870-1. It says that the voltage offset is less than 500 uV. I simulate this circuit using LTSpice, when driving ada4637-1 with 0V and monitor the output of ADA4870-1, it is…

  • LTC4269-1 current spikes

    I'd like to use the LTC4269-1 (LTC4269IDKD-1#TRPBF) in a design, but I'm seeing current spikes that are too high on the eval board (DC1335B-C). How can you explain this and what can I do to reduce them below the peak current threshold (684 mA)?…

  • RE: LT3791-1 - EMI

    Hi Vagelis,

    EMI can be complicated with causes from component choices to board layout. It is very design dependent. I recommend that you contact ADI FAE in your area to help you out. 

  • ADF7030-1

    Hello,

    I bought the ADF70301 - 433 EZKIT and I can't find, in the ADF70301 data sheet, the noise figure of the transceiver. 

    So I'm here to ask: how can i measure the noise figure of the ADF70301 using the 433EZKIT?

    Thank you for your support

  • ad7656-1

    I'm requesting the gerber files for this product mentioned above... is it possible to receive them. thanks, 

  • Proper application of ADF7020-1?

    Greetings community.

    I'm setting out to design a module for integration into a larger [wired] building management system that will listen on a fixed frequency (or better yet, cycle through a pre-defined batch of frequencies) in the NOAA weather radio…

  • LTC2439-1

    Hi!

    We wanna use the LTC2439-1 configured with 16-Channel Single-Ended Inputs, the Reference-Voltage is 5.0V and the Input-Channel Voltages are from 0-5.0V

    But the datasheet does not clearly describe the function for us with this configuration.

    We are not…

  • AD7988 - 1

    Good afternoon....

    I currently am using the above subject successfully in a design.  The power supplies are as follows: Vref = 2.5V, VDD = 2.5V and VIO = 2.7V - 3.6V.  Moving forward I would like to re-route the analog supply, VDD to track with VIO.  Can…