The Sense+ pin is connected to both Charger and Load. So,I would like to know how the LTC2942 could determine the operation mode between charge and discharge.
You didn't mention your application or the loop BW you're using so the following is assuming that REF / PFD, Icp etc. must remain as they are.
1) I don't recommend attempting to use the HMC767 for an 8.0 GHz application. Over process & temperature…
Hi- Yes, abs max is 6V. The UV and OV thresholds are different.
The datasheet says + - 20fA gauranted
however the datasheet rev B page 17 shows statistical data spreading way outside this for both inputs, in fact the plot states the standard deviation is about 20fA.
Which is correct ?
I see other people were querying…
I am trying to implement passive cell balancing with using external discharge circuit. As I read the datasheet of LTC6812-1 we need to configure DCC bit for the cell we want to discharge.
I looked into the configuration register group A and…
configured chip HMC7044 at cmos output mode.
It is working but I have some problems:
HMC7044 have 2 group
Group1: 3 clk + 4 SCLK same phase: CLK0, SCLK3, SCLK5, CLK6, SCLK9, CLK10, SCLK13.
Group2: 4 CLK + 3 SCLK same phase: other.
But group 1 and…
I want to use the AD7768-1 with 5V AVDD1 = Vref and 3,3V VDDIO. In demo-circuits the AVDD2 is connected to probably noisy VDDIO!Wouldn't it be better to supply AVDD2 from 5V over a R-C-Filter, that would lower the voltage to around 3V?
Hello I am having trouble communicate with this chip I have the address pin set to AD1 = 1 ADO = 0. I know I am suppose to send a command NOP command to read from the desire register.
I am sending the command in this format:
command = AD5755_WRITE_CMD…
should this combination of a ADA4666-2 and a ADC-converter work?