• ADA4311

    I was designing a signal generator for gain control(the signal frequence is 2MHz to 30MHz).I am using ADA-4311 opamps,which terminates with a 50 ohm resistor in my design.The maximum input voltage is 2vp-p and power support is 12v.
    I would like to know…

  • RE: About supply voltage of ADA 4310-1 (II)

    Hi Mochi,

    Apologies for the late reply. For your question if ADA4310-1 equivalent to the absolute maximum rating of ADA4311-1. The answer is no. Absolute values for the parts are ± 5% of 12V supply voltage for ADA4310-1 and 13.6V supply voltage for ADA4311…

  • RE: .file_attr 1="1";

    Hi, Thanks for replying. I had tried the "-no-auto-attrs" with no improvement. The same error reappears elsewhere if I delete the source file causing the problem. It also occurs in the standard "BF609_init" project, so I have attached those files. The…

  • ad7656-1

    I'm requesting the gerber files for this product mentioned above... is it possible to receive them. thanks, 

  • DigiPot 1/f noise

    Is there more noise data for 1KΩ DigiPots than the 1KHz spot noise spec in the data sheets? For example, the AD5253 (1K) shows 3 nV/√Hz at 1KHz which makes sense for a pure resistance in the neighborhood of 1KΩ. I am interested in the region of 0.1Hz…

  • LTC2439-1

    Hi!

    We wanna use the LTC2439-1 configured with 16-Channel Single-Ended Inputs, the Reference-Voltage is 5.0V and the Input-Channel Voltages are from 0-5.0V

    But the datasheet does not clearly describe the function for us with this configuration.

    We are not…

  • ADF7030-1

    Hello,

    I bought the ADF70301 - 433 EZKIT and I can't find, in the ADF70301 data sheet, the noise figure of the transceiver. 

    So I'm here to ask: how can i measure the noise figure of the ADF70301 using the 433EZKIT?

    Thank you for your support

  • RE: Configuration LTC6804-1

    Yes you can connect LTC3300-1 via SPI of GPIO pins. Please refer page 46 of datasheet you can find the same here.

    I hope this answers your query.

    Regards,

    Abhishek

  • AD7988 - 1

    Good afternoon....

    I currently am using the above subject successfully in a design.  The power supplies are as follows: Vref = 2.5V, VDD = 2.5V and VIO = 2.7V - 3.6V.  Moving forward I would like to re-route the analog supply, VDD to track with VIO.  Can…

  • ADUM4121-1

    Can ADUM4121-1 gate drive handle 100% duty cycle?