• ADA4304-2

    Здравствуйте. Можно ли использовать микросхему ADA4304-2 для разветвления RGB или S-Video сигналов?

  • RE: Video RF Splitters of ADA4304-2.

    Hi,

     The ADA4304-2 can be used buffer video signals

     Please refer below product page for ADA4304-2 Splitter

     http://www.analog.com/en/products/amplifiers/specialty-amplifiers/video-rf-splitters/ada4304-2.html#product-overview 

    Thanks,

    Poornima

  • ADA4304-4 Question

    In our product design, we use the ADA4304-4 chip to distribute the rf signal of cable digital TV, the 1 input of the rf signal is allocated to 4, in order to avoid the
    high-voltage electrostatic and leakage from rf signal input,we use a blocking capacitor…

  • Video splitter ADA4304-3

    Hello the ADA4304-3 can work as composite video splitter?

    1  composite video PAL/NTCS IN, 3 composite video PAL/NTCS OUT, to 3 different Analog monitors?

    If the answer is No, can you please suggest me how can I split 1 video IN to 3 video OUT?

    Thanks,

  • JPEG Processing - 4:2:2 v 4:2:0?

    My JPEG saga continue...

    I am using a BF561 single core to compress a 640x480 YUV 4:2:2 image into JPEG format, employing the ADI JPEG Library tools.  I am getting very poor performance compared with the reference results from the Spec Sheet.  The Spec…

  • ADV7842 4:2:2 DDR mode, ADV7393: Stanag3350 support?  (2)

    Hello Dave,

    I am facing problems with replies to your answer, so I am oppening a new dicussion with the same title.

    Please clarify your answer regarding STANAG support:

    2) As I understand it, this is the same as RS-343A/EIA-343A and none of our parts…

  • LTC6804-2 and LTC6811-2 reference voltage 1 and 2 at 0V.

    Hello,

    I installed 2x LTC6811-2 and then 1x LTC6804-2 on the same board and I don't have any voltage reference output at anytime. The functional diagram in the datasheets shows that VREF1 should be always present as it's generated from V+. VREF2 is not…

  • ADM1176-2 reset

    I am using the ADM1176-2 (latching) part on a new PCB design.  I am wondering if setting the SWOFF bit over I2C can reset the latch state the same as toggling the ON pin?  The datasheet isn't entirely clear on this aspect--on Page 16 Table 11, it states…

  • 2*2 MIMO setup

    Hello,

    Iam interested in implementing a MIMO 2*2 scenario where i will use 2 fpgas (1 as the transmitter and 1 as the receiver) where each one  will be connected with one AD-FMCOMMS3-EBZ.
    So the setup will be :
    FPGA_1 + AD-FMCOMMS3-EBZ_1 =Base stati…

  • ADV7403 YUV 4:2:2?

    Can the ADV7403 output YUV 4:2:2 rather than YCbCr 4:2:2?

    Thanks.

    Chris