• AD9988-FMCB-EBZ Schematics and PCB

    Hello, we bought an AD9988-FMCB-EBZ this week. we will run it in our own baseband.

    but, we can't find the schematics and PCB of AD9988-FMCB-EBZ. work can't be continued without pin definition, such as SPI, serdes ... 

    Where can I find the schemat…

  • AD9988 EVM question

    Hello Sir,

    In order to EVM is most important for digital communication system so customer would like to use AD9988 in front-end.

    We also know, AD9988 has integrated  high speed ADC+DAC so we don't have any EVM test result from DS.

    That the customer…

  • AD9988 EVM result

    Hi folks,

    I find the specification and relevant document, it doesn't mention about EVM measurement .

    Could you help to provide the EVM measurement result , the condition of measurement is 1024QAM@7.2GHz. 

    Thanks. 

  • DPD Support for AD9988

    Dear ADI Support,

    We created 100MHz B/W 5G signal and transmit it from DAC.

    The direct signal from DAC seems to be good on spectrum analyzer.

    However,  a signal via PA is not good. It is not sufficient with ACP.

    So, we want to use DPD(Digital Pre Distortion…

  • Does AD9988 support Tx or Rx only mode

    Dear ADI friends:

    We have a lot a FMC card projects, some are Tx only card, some are Rx only card, some are TRX card.

    We are considering AD9988 as a general solution for our FMC card projects.

    So my question is:

    In the uc_settings.c file, can we configure…

  • AD9988-FMCB-EBZ schematics

    Hello,
    I can't find the schematics of AD9988-FMCB-EBZ.
    Where can I find the schematics?

  • AD9988-FMCB-EBZ and ZCU102

    Hello,

    I have a question from our customer about AD9988.
    A ZynqMP / MPSoC Linux kernel is prepared for  AD9081 and AD9082.
    It is introduced on the bellow page.
     wiki.analog.com/.../zynqmp

    Our customer wants to use  zynqmp-zcu102-rev10-ad9081-m8-l4.zip (2019_R2…

  • AD9988 MxFE Software Quick Start Guide

    We will test AD9988 EVB (Single MxFE AD9988-FMCA-EBZ) with Xilinx FPGA EVB VCU118 and  there is no user guide document and example design for quick start, we found a exmple design of QuadMxFE with VCU118 for quick setup.  Is there similar quick start guide…

  • Can ADRV9008 produce 5G Tx signal?

    Hi

    I would like to create a system that outputs 5G Tx on your board and FPGA without using a signal generator.

    1.  AD9988
    2.  ADRV9008,9009

    I think AD9988 can do it. however the AD9988 is expensive. I would like to evaluate it with ADRV9008 first.

    We can convert…

  • RE: EVAL-AD9082-FCMA vs -FCMB

    More information is available in the user guide 1829 (AD9081/AD9082/AD9986/AD9988 User Guide (Rev. 0) (analog.com)). please see table 1.