I was able to verify that that the PLL locks using our ACE GUI software for similar clock settings. I attached the log file so that you can compare PLL settings between two cases.
youngpines, can you please provide some details about your setup? are you using the ADS9v2 along with the AD9081/AD9082-FMCA-EBZ? If so, have you taken a look at the user guides?
AD9081/AD9082/AD9986/AD9988 User Guide (Rev. 0) (analog.com)
Hello,I have a question about the CHIP GRADE of AD9082 from our customer.Our customer purchased a number of AD9082.He said that some AD9082 indicate 0x22 and another is 0x23.According to page-231 of UG-1578, 0x23 indicates AD9082, AD9986, AD9207.What…
EVALUATING THE AD9082 / AD9081 / AD9986 / AD9988 Mixed-Signal Front-End (MxFE) RF Transceiver [Analog Devices Wiki] has some basic troubleshooting information available. not all frequencies are supported by the hmc7044. i would start with that.
please use these references to evaluate the AD9082 with ADS9-v2
AD9081-FMCA-EBZ/AD9082-FMCA-EBZ User Guide (Rev. PrA) (analog.com)
EVALUATING THE AD9082 / AD9081 / AD9986 / AD9988 Mixed-Signal Front-End (MxFE) RF Transceiver [Analog Devices Wiki]
Hello,I have a question about the compatibility between ADS8-V1EBZ and ADS8-V3EBZ.ADS8-V1EBZ supports AD9213, AD9208, and some ADC and DAC which are listed on the ADS8-V1EBZ page.https://www.analog.com/en/design-center/evaluation-hardware-and-software…
Could I have a bit more info on how to configure the programmable filter for the AD9081 via the ACE software/plugin (using AD9081 eval board + ADS9 setup).
I can successfully load a 192-tap filter and receiver one channel as described in the wiki…
Hi, I originally posted this the high speed converter forum but did not get a response so am reposting here:
Could I have a bit more info on how to configure the programmable filter for the AD9081 via the ACE software/plugin (using AD9081 eval board…