• AD9516-0 with passive loop filter and external VCO

    Dear All,

    I need a technical support about the following issue involving the AD9516-0.

    I am using the AD9516 with external 820-870MHz VCO and passive loop filter. The PLL has been programmed to work at 860MHz and in this condition the VCO works at about…

  • Please tell me the power start-up conditions required by AD9516-0.

    My customers are using AD9516-0, and my customers are facing trouble.
    Customers surveyed about their products and concluded that power supply and POR are suspicious.
    Their products have a power supply that rises slowly.
    The supply voltage rises to 2.9 V…

  • Clock multiplication with AD9516-0/PCBZ

    Hi All:

    I have an AD9516-0/PCBZ. Can I use it to multiply my clock signal from 1 MHz to somewhere between 50 MHz and 120 MHz? If yes, how?


  • AD9516-0时钟芯片输出时钟频率有偏差


  • AD9516-0 软件导入问题



    2.导入后,是否是永久保存的?   我在使用时,发现断电后重开电源,评估板中的软件参数设置就恢复原始了,不是我保存的设置了。这应该如何解决呢?


  • can EVAL-AD9516-0 keeps the register setup?


    I want to use EVAL-AD9516-0 as clock source for AD9208. 

    I know that EVAL-AD9516-0 has convenient software.

    I wonder if the settings are stored when I set up the settings using the software.

    So, I wonder if EVAL-AD9516-0 keeps the settings even…

  • AD9516 reference spurs

    Dear All,

    I am using the AD9516-0 to clock the AD9122.

    • reference frequency = 122.88MHz
    • DAC sampling = 983.04MHz
    • PFD frequency = 61.44MHz

    Around the 983.04MHz, I can observe a lot of spurs every 61.44MHz.

    What is the maximum reference spurious…

  • RE: Mechanical drawing of AD9516-0BCPZ


    I recommend using one of the LVPECL terminations from the data sheet: figures 71, 72 and 73, page 78, rev C AD9516-0 data sheet. Read also the section LVPECL Clock Distribution at the same page for more info


  • AD9516

    1. 我们需要将1 MHz的激光器时钟信号输入到NI 5734模块,做时钟信号的同步。而NI 5734 的频率范围是50-120 MHz 。

    在ScanImage 官网上有推荐使用 AD9516模块提高频率(scanimage.vidriotechnologies.com/.../Synchronization to Laser Clock)

    2.在ScanImage 中实现光子计数也需要使用 AD9516(docs.scanimage.org/.../Photon+Counting.html)

  • ad9516

    I have two ad9516 evaluation boards, one is ad9516-1, the other is ad9516-5. When I used it, I found that the LD light on the ad9516-1 evaluation board could be normally lit after downloading the same program, but the LD light on ad9516-5 couldn't be…