• RE: AD9514 Low Frequency De-sync

    Mcee,

    Apologies for the delay. It appears that unfortunately for us the device we've been using to generate our clock frequency is not reaching the Slew rate requirements at low frequencies. So that would be the problem right there.

    It also appears…

  • AD9514 synchronization

    I feed AD9514 CLK input from AD9517 output. SYNCB pin of AD9514 is tied with CSB pin of AD9517. After AD9517 callibration finish I read state of AD9517 register once more to synchronize AD9514 outputs, but result is sporadic. What may be a reason of this…

  • AD9514 Clock;

    Hi Larry,

        We realized the AD9102 evaluation board has AD9514 chip already

    installed. We ordered a AD9514 Board. Does the Board buy us something we do

    not already have on the AD9102 evaluation board? Our group is up in arms

    about that - please comment…

  • AD9102/AD9514 Clock Problem

    Hello, I want to 40khz sine wave using AD9102/AD9514.

    (I have a AD9102 EVM Board It worked well.)

     

    I have some problem using AD9514 Clock divider.

    (I choose clock source 180Mhz crystal(XLL336180.000000I).)

     

    1. AD9514 OUT0(LVPECL) just DC Offset…

  • AD9514 with ADF5355

    Hello

    I would like to ask i am considering working with one of the components AD9520-4/   AD9514/5

    for DDS Clocking and, and i see alot of applications use the AD9520-4 for this purpose, but this component has a lot

    of Registers for the pupose i need…

  • AD9514抖动

    AD9514输入960MHz时钟，输出一路960MHz时钟(OUT0)，两路120MHz时钟（一路LVPECL(OUT1),另外一路LVDS(OUT2)），请问输出的960MH时钟抖动有多大？

  • AD9102/AD9514 Clock Problem

    Hello, I want to 40khz sine wave using AD9102/AD9514.

    (I have a AD9102 EVM Board It worked well.)

     

    I have some problem using AD9514 Clock divider.

    (I choose clock source 180Mhz crystal(XLL336180.000000I).)

     

    1. AD9514 OUT0(LVPECL) just DC Offset 2…

  • AD9514 flexible output configuration

    Hello AD community,

    I'm looking for help in configuring the outputs of the AD9514 clock distribution chip.

    In my project, I anticipate needing only one output, so I have OUT0 configured like I need it. However, I would like to keep my options open…

  • RE: AD9514 synchronisation setup and hold times of SYNCB with respect to CLK/CLKB

    Q 

    I would like to use two AD9514 with the same CLK/CLKB clock (it will be phase
    aligned for both). I will use the SYNCB input of both AD9514 to synchronize all
    clock outputs. What are the setup and hold times of SYNCB input with respect to…

  • RE: shift clock on AD9102

    I agree that you scope can't get the 1milli-degree resolution, but it should be sufficient for the 1.4 degree problem that you are trying to figure out. Currently you don't know if it is from AD9102 or AD7760 or AD9514 or the oscillator. If the scope…