• AD9278 (HSC-ADC-EVALCZ) Verilog Code Request


    Could you provide the Verilog code of HSC-ADC-EVALCZ evaluation board for AD9278? 

    I am using the board with AD9278 and need to modify the Verilog code. Thanks in advance!



  • AD9278-65EBZ/AD9278-80KITZ/AD9279-50EBZ or Evaluation Board and HSC-ADC-EVALCZ Data Capture Board 采集信号,频率偏移




  • AD9278增益问题



  • AD9278 & AD9252 Phase Response


    is there data available concerning the phase response of the analog inputs of your ADCs?

    Best regards,


  • AD9278-50EBZ + HSC-ADC-EVALCZ Acquisition from MATLAB has some errors

    %The following dlls are required for using the library.
    %These three dlls are needed in the same directory:
    %If you have installed VisualAnalog these dlls will be in the VisualAnalog
    %install folder…

  • The frequency of the templates FFT on VisualAnalog using Evaluation Board for AD9278 & AFE HSC_ADC_EVALC has regular errors


           We brought your AD9278 Evaluation Board and AFE HSC_ADC_EVALC board , and following the   "AD9278_79_EVB_User_Guide.pdf" , setting power, setting the SPI control.  Then we  using an signal synthesizer generate one 1MHz / Vpp=5V sine wave ,…

  • AD9278-50EBZ + HSC-ADC-EVALCZ Acquisition from MATLAB


    I have been trying to configure the AD9278-50EBZ and the HSC-ADC-EVALCZ for data acquisition.  I found the MATLAB script for acquisition on the AD9253 using the HadBoardApi and tried to adapt it (see code attached) to my hardware however, I have a challenge…

  • how to config ad9278 to generate test pattern

       I use the following command to write register of ad9278 through SPI. It seems it doesn't work.

    We have scoped the spi signals which look good. Please help to check if I missed something. Thanks.

    d_REG1 <= 24'h00_00_18 ;
    d_REG2 <= 24'h00_04_0f…

  • RE: AD9278 with HSC-ADC-EVALCZ drivers and documentation


    To work in Matlab x64 you need to add the following lines of code in before start making method calls to the DLLs:


  • AD9278 dinamic range

    Good afternoon
    We have problems with the AD9278. Unable to use the whole dynamic range.
    AD9278 distorts RF signal like in attached files.
    Maybe our connection/programming are wrong or this is normal operation for
    this chip?.
    Best regards Romas