FAQ
Pin 5 and 6 are In+ and In- as per data sheet. But the ECAD model has Pin 5 as In - and Pin 6 as In+
I'm trying to run an AC Analysis on a 9-pole 3 kHz low pass filter using the LT6235 model. The simulation does not seem to converge, even after a half hour. When I replace all of the LT6235's with LT6238s, it runs in a few seconds. When I replace the…
What are your supply rails? The LM747 will tolerate 22V supplies, which is more than most opamps will take.
The AD8513, AD8674 and OP470 may be worth a look as they all have better performance. I don't know about Mil spec though.
Bryan,
I wish you would have gotten a name so I could track this down further. Was it a local field office
or an office in Norwood? Which department? That is certainly unacceptable behavior.
I was the product line apps engineer for the ADA4627-1.
…| AD600 |
| AD602 |
| AD603 |
| AD604 |
| AD605 |
| AD8264 |
| AD8330 |
| AD8331 |
| AD8332 |
| AD8334 |
| AD8335 |
| AD8336 |
| AD8337 |
| AD8338 |
| ADL5246 |
| ADL5330 |
| ADL5331 |
| LTC6412 |
| HMC6187G |
| HMC997G |
| HMC996 |
| HMC694G |
| AD8368 |
| AD8351 |
| AD8367 |
| AD75071 |
| AD552… |
Good day,
I have a task to optimize noise in BW 10Hz - 10kHz.
Voltage gain shall be around 20..50. OA connected directly to source of signal,
which has impedance 1kOm DC and 50Om AC. OA connected to middle point of R1/R2 divider,
where R1 connected…
