• RE: AD8497 connected method

    Hi Patrick,

    You may refer to the application information in page 14 of the AD8497 datasheet where an example of a basic configuration for the AD849x with a J type or K type thermocouple input was discussed. See link AD8494/AD8495/AD8496/AD8497 (Rev. C)…

  • AD8497 Setpoint controller has three states?

    Hello as part of my bachelorthesis i am working on a setpoint controller for the temperature. therefore i used the ad8497. But the amplifier is not working properly. Because the sensor has 3 states. One state for off which means 0V and one state for…

  • RE: Slightly high voltage output on AD8497.

    This question has been closed by the EZ team and is assumed answered.

  • Output range problem for AD8497

    Hi. I am using AD8497 for K-Type thermocouple measurement. I have given supply of +5v and 0V. and Ref voltage of +0.5V. My input signal ranges from -2.0mV to 70mV. I get output signal only for input signal upto 40mV. Please suggest schematic for measuring…

  • RE: ad8497 pull-up

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    …

  • RE: Thermocouple amplifiers AD8495/AD8497

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    …

  • RE: Query about AD8497 Output

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    …

  • RE: Looking for a PCB layout sample for AD8497

    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    …

  • AD8497 with mux

    Can I put an analog mux in front of an AD8497 to read multiple thermocouples with one device?

  • AD8497:negative temperature & unipolar supply.

    Hellow,

    AD8495/AD8497: according to datasheet,

    'Reference pin voltage can be offset to measure 0°C on single supplies.'

    Question1:

    Is this also applicable for negative temperatures,

    i.e., is it possible to use unipolar positive power supply…