• RE: Rθjc of AD8314ARMZ

    Theta JC for the MSOP version of AD8314 is approx. 44 degC/W.   -Bruce H.

  • AD8314_Disable

    Hello

    I have one question. Please tell me.

    Is voltage output to [V-UP] when AD8314 is the disabled mode?

    Best Regards.

  • RE: AD8319

    Hi Stefano,

    Sorry, I do not have the AD8319 temp data for VHF.

    You might consider AD8314, which uses a very similar core detector circuit as the AD8312. There are two package choices, MSOP and LFCSP. Typical temperature curve is provided for VHF.

    -Bruc…

  • RE: AD8302 at 150MHz (Reflectometer application): matching networks and corner frequency

    Please see attached AD8314 s-parameters. 

    • AD8314ACP_S11.zip

  • Queries about ADL5501 in GSM Application

    Hi,

        I ‘m now studying ADL5501 for my project and please kindly provide technical advice on below questions.

    1, the input source is GSM signal. So do you expect burst output signal (instead of continuous DC voltage) at output of RF detector? Or put…

  • RE: AD8302 to be used as an RMS power detector

    Hi Vishnu,

    What is the input power range you are trying to measure?  We have several low power log amps and RMS detectors found on this page:

    http://www.analog.com/en/rfif-components/detectors/products/index.html

    I would recommend taking a look at the…

  • RE: Dynamic Range of AD8367

    Hi J S Hyanki,

    You can use the AD8309 in an AGC loop, much like what is shown in the AD8367 datasheet and the attached paper above (or you can you an AD8361 as shown in both).  What did you like about the AD8309 that made you choose it?

    If you don't…

  • RE: Re: Cell Phone detector RF component.

    I would not recommend AD8311 as it is a detector-controller. So its normal use case is to detect the signal at the output of a variable gain amplifier (or variable bias PA) and then adjust the gain of the variable gain element until its output power is…

  • FAQ: How can I avoid startup transients when operating the AD8318 in Controller Mode?

    Q.

    How can I avoid startup transients when operating the AD8318 in Controller Mode?  I am using the AD8318 Log Detector/Controller to control  the output level in an AGC loop.  The control loop consists of a fixed-gain  RF amplifier, an ADL5330 VGA, a…

  • TAGS LIST: Amplifiers

    AD600
    AD602
    AD603
    AD604
    AD605
    AD8264
    AD8330
    AD8331
    AD8332
    AD8334
    AD8335
    AD8336
    AD8337
    AD8338
    ADL5246
    ADL5330
    ADL5331
    LTC6412
    HMC6187G
    HMC997G
    HMC996
    HMC694G
    AD8368
    AD8351
    AD8367
    AD75071
    AD552…