• AD7616-P FAQ - What are the differences between the AD7616 and AD7616-P?

    The AD7616 and AD7616-P have similar functionality, with a few key differences.

    • The AD7616 has both serial and parallel digital interfaces
    • The AD7616-P has a parallel only digital interface
    • The AD7616-P has relaxed timing requirements on read…
  • RE: 请教一下AD7616软件并行模式读写时序问题

    你用的芯片是AD7616还是AD7616-P, AD7616-P的并口时序兼容控制器的时序会更好。

  • AD7616-P FAQ - When using the software sequencer, the first conversion result is not the expected value?

    After configuring the sequencer in software mode, a “dummy” conversion is first required in order to latch the configuration into the ADC. After one dummy conversion has been performed, the ADC is fully configured for use with the sequencer and no further…

  • Multi-channel ADC for auto telemetry

    Hello, I'm looking for a multi-channel (>=16) ADC with 0..16V inputs. The project is telemetry system for an old car with analog sensors. It seems that AD7616 (EVAL-AD7616) might fit but there is a little misunderstanding about it.

    Manual says…

  • AD7616 channel synchronization???

    Hi,

    i'm trying to use ad7616 for new design which is having more than 80 channels on 2FMC's and i need to design for synchronized data... can anyone tell me how to use this IC for synchronization purpose without any clk or sync pin's.

    and…

  • About multi channel synchronization with AD7616

    Hi,

    i'm trying to use ad7616 for new design which is having more than 80 channels on 2FMC's and i need to design for synchronized data... can anyone tell me how to use this IC for synchronization purpose without any clk or sync pin's.

    and…

  • RE: How to retrieve the data captured by AD9694 Eval board from ADS7-V2EBZ FPGA

    Hi UmeshJ,

    The provided code is meant for AD7616 Eval board:

    client.ContextPath = '\System\Subsystem_1\AD7616 Eval Board\AD7616';

    Could you please confirm if you have tested the code on AD9694 Eval board, as well?

    Please also let me…

  • ad7616

    Does AD7616 requires an external reference clock?

  • AD7616

    Hi,

    Do i need an Isolation ADUM to separate AD7616 serial interface from the MCU ?

    Also, do i need to isolate the power for the AD7616 ?

  • RE: I am working with AD7616 and interfacing with MC9s12xdp512 controller using spi. I am using the software serial mode. I am unable to write and read the registers properly. Please provide the code for accesing AD7616 using spi.

    Hi Vara,

       

       There is AD7616 wiki page that has information on software driver that can use as your reference. Figure 59 and 60 details the timing diagram when writing to and reading from AD7616. It is recommended to perform reset after AD7616 power up.…