I have a question AD5696 UG-532.
I see that AD5696 GAIN and RSTSEL Pin is connect to VLOGIC or GND.
If i want to connect VLOGIC , Pull-up resistor is pull-up resistor necessary?Is there recommendation of pull-up resistor?
I would like to confirm a thing. Is it possible for you to check?
I think CPU should be master, DAC should be slave.
During READ OPERATION, master and slave are changed.
According to the timing chart of P22 on the datasheet of AD5694R…
I bought the AD5696 evaluation board EVAL-AD5686RSDZ and control board EVAL-SDP-CS1Z,I can use AD5696R evaluation software to convert a digital quantity into analog quantity manually, but I need to convert digital quantity into analog quantity continuously…
Hello, I have 3 of the AD5696 on a board and I'm trying to communicate via i2c (100khz) to update the outputs. Each of them have a different address (see sch below). The addresses are 0b0001100, 0b0001110 0b0001110 (0x0C, 0x0D, 0x0E).
设置A，B, C，D通道各为：0.825V, 1.10V, 1.65V, 3.30V
I bought the AD5696 evaluation board EVAL-AD5686RSDZ and control board EVAL-SDP-CS1Z
,I can use ACE software to convert a digital quantity into analog quantity manually, but I need to convert digital quantity into analog quantity continuously and automatically…
I have a problem with the i2c Interface of the AD5696R.
I wrote a test procedure with the intention to test my read an write function for an EEPROM which shares the bus with two of these DACs and some other IC. This functions sends multiple bytes…
I couldn't receive reply.
So I copy this as new discussion.
It is difficult for us to understand AD5696R I2C READ operation on figure 51.
Because all of the ACT by MASTER.
I would like to confirm a thing. Is it possible for you to check…