• AD5259 I2C Device Address

    Q 

    I would like to ask you about the I2C device address of AD5259. According to
    the documentation the complete address is changing by pins AD1 and AD0. In case
    of other components of the AD525x series the address is 0x58. Does the address …

  • AD5259 communication problem

    Hi Engineering Zone,

    I encountered the following problem when during my design. AD5259 digi-pot having communication issue with my LT IC. This happen when my ST Micro-controller was burnt during my testing adjustment and after i changed to another new…

  • AD5259 Power down

    Hi

    AD5259 power up sequence is

    GND, Vdd, Vlogic ,digital inputs and then VA,VB,VW.

    Power down sequence should reverse this, I think.

    Does AD5259 accept Vdd=VA=VB=VW=0V and Vlogic=5V ?

    Abso max accepts this, so it should be ok, I think.

    Could I make…

  • AD5259 i2c device adress

    Hello

    we want to use the AD5259 in a design.

    In the doc is no device adress noted.

    If i read the doc in the right way, there is a change over the

    whole adress by setting ad0 pin. Normally there is a change of only 1bit.

    On this device the change…

  • I2C line of AD5259

    Please teach me I2C line of AD5259

    SCL, SDA pin it will pull up as shown in Figure 46 and 47.
    But,the power supply circuit of the MCU and  AD5259 has been separate.
    It is a circuit configured to pull up the SDA,SCL by using the power of the MCU.

    When the…

  • AD5259 power-up sequence

    Is it possible to tie VLogic/VDD/VA together?

    Thanks

  • Total wipe resistance of AD5259

    Hi

    Please let me know about  these fundamental questions of AD5259.

    Datasheet says

    RWA(D)={(256-D)/256}XRAB   + 2 X Rw      (2)

    Total wipe resistance  Rwb is 75 ohm typ @ Code 0x00

    What is the relation between  these specs and Zero scale Error?

    2X Rw  = Rwb…

  • AD5259 - "Not Connected Option - third logical stage "1", "0", "NC" ??

    Q 

    in the Rev 0. of the AD5259 datasheet there is a table showing the possibility
    to address 9 devices.

    On stage is called "NC"


    meaning I have A0 and A1

    and the ligic Levels "1", "0" and "NC"…

  • The Difference between old and new evaluation board of AD5259

    Hi,

    My customer has used old evaluation board of AD5259 which name is AD5259EVAL but currently this board was obsoleted. So customer consider to buy latest one named EVAL-AD5259DBZ (and EVAL-SDP-CB1Z).

    The questionis , can we use software of AD5259EVAL…

  • RE: 詢問IC P/N

    AD5259

    http://www.analog.com/cn/products/digital-to-analog-converters/digital-potentiometers/ad5259.html#product-overview