• AD5142A Steps for Reading Registers

    Can you provide me the steps for reading back a register from part number AD5142A?

    I'm able to write to the device, but I'm not having any luck reading back.

    Both ADDR0 and ADDR1 are grounded in my setup.

    If you could give me the step by step process…

  • AD5142A


    数字电位计AD5142A双电源Vdd=+2.5V,Vss=-2.5V，Vlogic=1.8V，addr0和addr0接地，发送地址0101111，AD5142A不能产生ack信号（I2C应答信号），断开Vss供电后，AD5142A就能应答，与主设备正常通信，

  • I2C Code Example - AD5142A

    I need to get a Digital Potentiometer (AD5142A) up and running quickly using I2C.  Can anyone point me to an I2C code example initializing and commands for the AD5142?  ad5142a

    Thanks!

  • AD5142A I2C command

    Hello

    Could you teace me  your advice if my understanding is correct about AD5142A I2C command.

    Question1

    I understand as below about command of RDAC1 read  (I do not dexcribe ACK).

    Is my understanding correct ?

    step1: transfer slave address and R/W =…

  • AD5142A startup wrong RDAC value

    1) Main problem is start AD5142A with wrong numbers in RDAC. INDEP pin =1.

       1 $5E,$14,$CF (I2C Addr, Command+Address, Data) write 207 to Raw1

       2 $5E,$10,$CD     write 205 to Rwb1

       3 $5E,$74,$01 and $5E,$70,$01  (copy to EEPROM)

     

    4 turn off /on power…

  • AD5142A Variable Gain AN-1264

    I am asking about the use of the AD5142A as a two channel variable gain resistor on the AD8421 op amp within the app note 1264. Is there any reason not to use this part in the high precision signal processing into a AD7195? The system will not employ…

  • AD5142A Divider mode and Rheostat mode

    Hello all,

    I'd like to ask you about AD5142A with Divider Mode and Rheostat Mode.
    I assume the use of the following.
    AD5124 has two potentiometers, one of the potentiometer is Divider Mode, one of the potentiometer is Rheostat Mode.

    Q1.
    In one of the…

  • AD5142A hardware protect RDAC and EEPROM

    Main problem is start AD5142A with wrong numbers in RDAC. INDEP pin =1.

       1 $5E,$14,$CF (I2C Addr, Command+Address, Data) write 207 to Raw1

       2 $5E,$10,$CD     write 205 to Rwb1

       3 $5E,$74,$01 and $5E,$70,$01  (copy to EEPROM)

     

    4 turn off /on power supply…

  • AD5142A as T-attenuator or voltage divider

    Hello,

    I just designed a moduled AGC-circuit. Amongst other things there is a fixed gain module and an adjustable attenuation moduel (AD5142A).

    I got problems with the attenaution module. It's just a AD5142A connected as follows...

    Signal goes…

  • AD5142A Power-up sequence and RESET pin

    Hello, help needed

    Power-up sequence: Can VLOGIC and digital inputs power-up before VDD?

    Hardware protection of EEPROM and RDAC register: How is this made? (not described in data sheet)

    Timing on RESET pin: Data sheet say maximum 10us. Is this correct…