• What is the difference: AD5060, AD5061, AD5062 and AD5063?

    What are the differences between the AD5060, AD5061, AD5062 and AD5063 low voltage single channel 16-bit resolution DACs?

  • Counts setting in DAC AD5062

    We are facing problem regarding SPI communication with AD5062 DAC .

    we followed the data communication sequence as per the datasheet .

    Ref voltage given to IC is 4.094V.

    Pass the digital counts & got the analog voltage as mentioned below-

    Count …

  • RE: [AD5061] Datasheet typo? (Vbf pin doesn't exist)

    Hello sofy,

    This is an error in the figure. You only need to connect Vout to the + of the amplifier. The AD5062 is a similar DAC that shows the circuit correctly in figure 43

  • RE: AD5066 noise model

    That is a reasonable approximation. The reference buffer noise may be a bit better. The plot below is from the AD5062 which uses a very similar buffer to the AD5066. A value of 25-30nV/rtHz may be more accurate but 60 is a good value to keep some safety…

  • RE: AD5040, AD5060, AD5061, AD5062 and AD5063 evaluation board software commands

    This question has been closed by the EZ team and is assumed answered.
  • ADI芯片辨识、型号查找

    看看截图:

  • Question for your ADP5062 again

    Can anyone expert  reply about this?

    This sled seems to broken, so I put this again here.

     

    Thanks

     

     

    ----

    Dear Sir/Madam,

     

    Our customer is studying with your power ADP5062.
    So he has brought as following questions. I needs your good comment here…

  • RE: nanoDAC-What are nanoDACs?

    nanoDACs are a portfolio of products which combine small package, low power and low cost digital to analog conversion.

    nanoDACs are monotonic DACs which can be powered off a single 3V or 5V supply and are available in the industries smallest packages…

  • Resolving to 16 Bits Using a Precision DAC

    I’m using a 16-bit DAC in an industrial control application and I’m having a hard time resolving the LSB.  I know I need to reduce the noise floor – what areas of the application should I address that will have the most impact on the DAC output?". …

  • nanoDAC - Which DACs should be used for open loop systems and which DACs should be used in closed loop systems?

    It must be stressed that depending on the application performance requirements, all nanoDACs can be used in both open and closed loop systems.

    In an open loop application the DAC drives the load (a valve or an actuator, for example) directly while in…