The SDP-S cannot connect to the EV-RADAR-MMIC2

Question

We have created an evaluation board based on the EVAL-RADAR-MMIC and are using it to connect to the SDP-S via a 120-pin connector. However, the evaluation board is not being recognized, which seems to be an issue with the EPROM. How can I program the EPROM?Can you provide the EPROM file? 
 Thank you very much.

emrecangidik · Accepted Answer

Hi 
 You can use the below steps to recover the EEPROM contents. 
 Extract the EVAL-RADAR-MMIC.zip file and use the EVAL-RADAR-MMIC.dat file to program the EEPROM ID. 
 
 Connect the SDP-S interface board to the Eval board and connect to the host machine via a USB cable. 
 Open the ACE Software 
 Click Tool&agrave; EEPROM Recovery Tool from the side panel (Figure 1) 
 Click Connect (Figure 1) 
 Select the .dat file with the correct hardware address 
 Select Connector Type as Arduino 
 Define correct I2C address (It can be between 0x50 &ndash; 0x57) 0x52 for EVAL-RADAR-MMIC 
 Click the Write EEPROM button 
 If the Write Complete pop-up appears, EEPROM values are updated. 
 Click Disconnect 
 Reset the SDP-S board

EVAL-RADAR-MMIC.zip)

opensky · Answer

Hi, 
 We have successfully resolved the issue using the provided files and steps. Thank you very much. 
 Best Regards！

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

The SDP-S cannot connect to the EV-RADAR-MMIC2