how to change the IP address of Zync platform (EVAL-TPG-ZYNQ3).

Question

Hi, 
 my name is Haim Litvak 
 I works with EVB of ADRV9009 
 I want to know how to change the IP address of Zync platform (EVAL-TPG-ZYNQ3). 
 Please advise 
 Thanks 
 Haim

vanitha · Accepted Answer

For Linux based image, refer to the below link for step by step process on booting the board: 
 https://wiki.analog.com/resources/tools-software/linux-software/zynq_images#preparing_the_image 
 Once you are able to boot the board , you can connect it through the serial interface first try pinging the board , and then check the Default IP Address using ifconfig and then change the network interface configuration through the below command . 
 vi /etc/network/interfaces)

haim_l · Answer

Hi Vanitha, 
 I detected the "root cause" of the problem with RX Power Input. The problem was in RF cable. I replaced the RF cable. 
 After replaced the RF cable I received the expected Power Input levels. 
 For Pin=-9dBm and RX 1 Gain Index=255, I received the ~0dBFS, and in time scale: I , Q Levels=~+/-32000. For CW=1MHz and 10MHz. 
 
 Thanks 
 Haim

Electronic Design Services - PartnerZone

Products Mentioned

how to change the IP address of Zync platform (EVAL-TPG-ZYNQ3).